Panasonic WV-CF420 Operating Instructions page 2

INSTALLATION
Important Notices:
• The following installation should be made
by qualified service personnel or system
installers and should conform to all local
codes.
• Be sure to use a ceiling board having
enough strength to support this camera.
• Do not use the camera at a place where it
may be exposed to oil splashes.
Oil can cause cracks in the part where the
camera is mounted.
Mounting the camera (by leading the cables
through a hole in the ceiling)
To make a hole for the cables in the ceiling
where the camera is to be installed, proceed
as follows:
1. Determine the place on the ceiling where
you want to install the camera. Then make
a hole (approx.
referring to the diagram at right.
2. Detach the panel cover by rotating it coun-
terclockwise.
3. Pass the cables through the cable hole.
4. Connect the cables as shown in the dia-
gram.
5. Mount the camera onto the ceiling by fix-
ing it with the mounting screws.
Note: The arrow mark on the camera's
base plate indicates the direction of
the camera and coincides with the top
of the image displayed on the monitor.
To monitor images in upright position,
confirm that the arrow mark points in
the right direction before fixing the
camera with the screws.
6. Attach the panel cover to match the
"Panasonic" logo and arrow mark, and
rotate the cover clockwise. Make sure the
panel cover is closed firmly.
15 mm) in the ceiling
15 mm (9/16")
Arrow mark
Arrow Mark for
upright positioning
of image
To AC Adapter
To Video Input