Listening To Cds; Normal Play; Program Play; Cd Play Modes - Panasonic RX-D23 Operating Instructions Manual

Normal play

2 3
1 Switch [ ] to "CD".
(Power comes on.)
2 Push [c CD OPEN/CLOSE] to
open the CD lid and insert the
CD.
Label must face
upward.
3 Push [c CD OPEN/CLOSE] to
close the CD lid.
4 Press [-/ J] to start play.
Play starts from the first track and
continues to the last track.
5 Adjust the volume.
To stop play
Press [L].
To pause Press [-/ J] during playback.
To resume, press [-/ J].
Hold down [–/ g] (backward) or [f/+]
To search forward/
backward (forward) during playback or when paused.
Press [–/ g] (backward) or [f/+]
To skip forward/
backward (forward) during playback or when paused.
"NO DISC" is displayed if there is no disc in the unit.
Note
• If interference occurs to radios or televisions, place the unit as far as
possible from this equipment.
• Do not press [c CD OPEN/CLOSE] during play, pause or immediately
after you inserted the CD and closed the CD lid. CD may be scratched.
This unit can play CD-DA (digital audio) format audio CD-R that has
been finalized (a process that enables CD-R players to play audio
CD-R) upon completion of recording.
It may not be able to play some CD-R due to the condition of the
recording. It cannot play CD-RW.

Listening to CDs

1 5
4
Total playing time
Total number of tracks
Elapsed play time
Track number in play

Program play

You can program up to 24 tracks.
Ensure CD is stopped before programming.
1 Press [–/g] or [f/+] to
select the desired track.
2 Press [MEMORY].
The track is programmed.
3 Repeat steps 1 and 2 until you
have programmed all the
tracks you want.
4 Press [-/ J].
Play starts in the programmed order.
To stop play
Press [L].
"P" is displayed indicating that the program is still active.
Press [L] again and "CLr" is displayed; the program is cleared, and the
normal play mode is restored.
To check program contents
Press [–/ g] or [f/+] when "P" is displayed.
Display
"— —:— —": Program equals, or exceeds, 100 minutes but programming
and play are still possible.
"FULL": 24 tracks have already been programmed. The program is
full.

CD play modes

You can repeat one track (
random order ( ).
Press [CD PLAY MODE] before or during playback to select
the desired mode.
These modes remain active until canceled.
You can use repeat mode with program play.
Note
Random and program play cannot be done at the same time.
4
RQT6742
2 1 4
Track number Play time
Program order
Specified track number
Total play time of
programmed tracks
), all tracks ( ) or play the tracks in
off (no indication)