Panasonic Viera TX-P42V20E Operating Instructions Manual page 95

Problem
Cannot connect to the network
Cannot select the file during
DLNA operations
Cannot operate VIERA CAST
The TV does not switch On
The TV goes into
"Standby mode"
The remote control does not work
or is intermittent
Parts of the TV become hot
Permanently lit spots on screen
Overcurrent error message
appears
An error message appears
●
Check the LAN cable or Wireless LAN Adaptor is connected
properly. (p. 69)
●
Check the connections and settings. (p. 69 - 73)
●
Check the network equipment and network environment.
●
The router may not be set to issue IP address automatically. If the
network administrator prefers to allocate an IP address, set an IP
address manually. (p. 71)
●
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 70) and set the router to be
able to use it.
●
If the problem persists, consult your Internet Service Provider or
telecommunications company.
●
Is media server of the connected equipment prepared? (p. 68)
●
Check applicable data format. (p. 68)
●
Check the connections and settings. (p. 69 - 73)
●
The server or connected line might be busy now.
●
Check the mains lead is plugged into the socket outlet.
●
Off Timer function is activated.
●
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 8)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within about
7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright light
not to shine on the TV's remote control signal receiver.
●
Even when the temperature of parts of the front, top and rear
panels has risen, these temperature rises will not pose any
problems in terms of performance or quality.
●
Due to production process involved in this technology this may
result in some pixels which are permanently lit or unlit. This is not a
malfunction.
●
The connected USB device might cause this error. Remove the
device and turn the TV Off with Mains power On / Off switch, then
turn it On again.
●
Check if foreign objects are inside the USB port.
●
Follow the message's instructions.
●
If the problem persists, contact your local Panasonic dealer or the
authorized Service Centre.
Actions
95