Power Supply Over The Low Voltage Socket (Max. 1 A); Carrying Out Connections - Kompernass TRONIC KH 3002 Operating Instructions Manual

2. Then insert the 12 V plug of the vehicle adapter
in the 12-V plug resp. in the cigar lighter of
the vehicle.
Danger!
The above sequence is important, as it avoids a short
circuit due to inadvertent contact of the appliance
plug with the vehicle chassis.
3. Place the main switch 2 at the front of the appli-
ance to the "CHA" position. The Energy Station is
now being charged.
4. While the Energy Station is charging, the red LED
"On" 6 in the field CHARGE will be illuminated.
5. When the battery is nearly fully charged, the
green LED "Full" 6 will start to be faintly illumi-
nated. As soon as it is fully illuminated you can
remove the vehicle adapter
6 continues to glow until you place the main
switch 2 in the position "OFF".
Notice!
A charging process is only established if the charging
voltage is higher than that of the battery. With a sta-
tionary vehicle this is frequently not the case. Gene-
rally speaking, charging is therefore only possible
with the engine running.
Power supply over the low
voltage socket (max. 1 A)
Caution!
Before performing any connections, always check
to ensure that both the appliance to be supplied
and the Energy Station are switched off. Place the
main switch 2 in the "OFF" position (centre position).
In this way you can avoid damage through connec-
tion faults.
. The red LED "On"
- 41 -

Carrying out connections

A total of 5 low voltage connection sockets 4,
from 3 - 12 V, are available for the supply of power
to appliances with a maximum power consumption
of 1 A:
1. Insert the adapter cable
connection socket 4 corresponding to the voltage
required for the appliance to be supplied.
2. Select the suitable adapter connector
input to the appliance being supplied.
Caution!
Ensure that "Positive" and "Negative" have not
been switched. Otherwise your appliance could
be damaged!
3. Connect the selected adapter plug
adapter cable together so that positive and
negative correspond to the markings on the
sockets of your appliance.
Polarity of the adapter plug:
• Should the adapter plugs
positive to positive and negative to negative on
the adapter cable
positive is above resp. inside and negative is
below resp. outside.
-
in the low voltage
for the
and the
be connected with
, then on the adapter plugs
+