Names Of Parts; Indoor Unit, Outdoor Unit - National CS-MC120AKH Operating Instructions Manual

Names of Parts

Indoor unit
Air purifying filter
Air purifying filters are
attached to the inside
of the air filters.
Air filter
Louvre (vertical blades)
The louvre is inside of the air
outlet.
(See page 8 "Adjusting the Air
Flow Direction".)
Flap (Horizontal blade)
(See page 8 "Adjusting the
Air Flow Direction".)
Opening the front grille
How to open the front grille: (See page "Care and Cleaning")
Before opening the grille, be sure to stop the operation
and turn the breaker OFF. If the power is on, the fan may
rotate inside and may cause injury.
ON/OFF switch
• Push this switch once to start operation. Push once
again to stop it.
• The mode is set to COOL, the air flow rate to AUTO
and the temperature to 22°C. (see page 8 "DRY/
COOL/FAN Mode operation.")
• This switch is useful when the remote controller is
missing.
4
Air inlet
Air outlet
Indicator lamps
OPERATION lamp (green)
ON/OFF switch
CAUTION
Outdoor unit
Air inlets
Front grille (Back and side)
Grille tab
Diffuser
POWER
Control panel
Room temperature sensor:
• senses the air temperature around the unit.
Receiver:
• receives signals from the remote
controller.
• When the unit receives a signal,
you will hear a short beep.
Earth terminal:
is inside of this part.
Air outlet
Refrigerant piping and
inter-unit cable
TIMER lamp (yellow)
(See page 9 "Timer
Operation".)
CLEANING lamp (red)
TIMER FILTER
OFF/ON
Lights up when the air
filters need cleaning.
(See page 10 "Care and
Cleaning".)
CLEANING lamp
reset button
• Push this button to
turn the CLEANING
lamp off.