Table of Contents
Advertisement
8
I
nstallation
Connect the drain hose
Connect the drain hose to the outlet
of the drain pump located at the rear
of the washing machine.
NOTE :
• Never lay down the drain hose, as water will be discharged.
• Be sure the drain hose is properly routed so it will not kink or lift from the sink.
• To prevent syphoning,the drain hose should not extend more than 50 mm from
the end of the hose guide.
• The discharge height should be approximately 0.9~1.2m from the floor.
"Washing machine is to be connected to the water mains using new hose-sets and that old hose-sets should not
be reused "
Flooding drainage
• Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any water
that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole (or
slope) that will prevent any possibility of water damage to floor coverings or property.
Connect the inlet hose
• Check that sealing washers are firmly seated.
• Attach the curved end of the hose to the inlet valve of the washing
machine ; Tighten the coupling nuts securely by hand. (Fig.1)
• Attach the straight end of the hose to the tap.
Tighten the coupling nuts securely by hand. (Fig.2)
• Another hose can be attached to hot inlet valve and tap.
• Turn on the taps and check for leaks. Tighten the coupling nuts firmly
if there is any leakage. If water pressure is strong, close the water tap
completely then open it slightly.
CAUTION
Attach the clip to the drain hose.
And then push it toward the body of
the washing machine as indicated by
the arrow.
Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
Plug the power cord of this washer into a properly installed standard power point that is switched &
earthed.
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL
FLOW of any water that may leak out should the machine malfunction. It is therefore the OWNER'S
RESPONSIBILITY to make sure this machine is installed in an area with a drain hole (or slope) that
will prevent any possibility of water damage to floor coverings or property.
Permissible water temperature : Max 70°C (160°F)
Permissible water pressure : Max 80psi (550kpa, 8kg/cm
If water temperature &pressure is greater than above, it may cause damage to the machine. If you
have uncontrolled water temperature & pressure you should fit a temperature & pressure relief valve
to ensure that water temperature & water pressure remains within the safe limits. Consult a plumber
or electrician if you are unable to adjust water temperature and pressure.
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
Place the hose guide over the
laundry tub or the stand pipe.
Do not use an extension hose.
Wlthin 50mm
Hose Guide
Drain Hose
INLET
VALVE
TAP
SEALING
WASHER
TAP
END
SEALING
MACHINE
WASHER
INLET
END
HOSE
(Fig. 1)
), Min 4psi (30kpa, 0.3kg/cm
2
0.9~1.2m
TWIST
(Fig. 2)
)
2
Advertisement
Table of Contents
