Connecting The Transmitter To Your Audio Source - Optimus 900 MHz Owner's Manual

33-1165.fm Page 3 Tuesday, August 10, 1999 10:50 AM
PREPARATION
Before you can use your headphone
system, you must find a suitable loca-
tion for its transmitter, away from any
obstructions and within reach of a
standard AC outlet. Then make the
necessary transmitter connections.
CONNECTING THE
TRANSMITTER TO YOUR
AUDIO SOURCE
Caution: Do not connect the transmit-
ter to the audio source's speaker out-
put. Doing so could damage the
transmitter and audio source.
Connect the transmitter to your audio
source's stereo headphone jack or to
separate left and right audio output
jacks (if available). If you connect to
audio output jacks, you can use the
headphone system's volume control
to adjust the volume without turning
up your audio source.
To connect the transmitter to your au-
dio source's stereo headphone jack,
plug the single ( 1 /
supplied Y adapter cable into the
headphone jack and connect the other
ends into the supplied stereo audio
cable (red plug to red jack and white
plug to white jack). Then connect the
red plug to the transmitter's
-inch) end of the
8
R/AUDIO
jack and connect the white plug to
IN
the jack.
L/AUDIO IN
Note: To connect a Y-adapter to a
inch headphone jack, attach the sup-
plied 1 / -inch adapter plug over the
4
plug and complete the connections.
To connect the transmitter to your au-
dio source's audio output jacks, con-
nect one end of the supplied stereo
audio cable to the transmitter's
and
DIO IN L/AUDIO IN
to and white plug to
R/AUDIO IN
). Then plug the other ends into
DIO IN
the audio source's audio output jacks
(red plug to the right channel, and
white plug to the left channel).
1
/ -
4
1 /
8
R/AU-
jacks (red plug
L/AU-
3