LG LMVM2085SW Installation Instructions Manual page 14

STEP 5: INSTALL THE MOUNTING PLATE
The Oven Must Be Connected To At Least One
Wall Stud.
1. Draw a vertical line on the wall at the center of the 30 wide
space. Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making sure
that the tabs are against the bottom of the cabinet. Line up
the notch and center line on the mounting plate to the
center line on the wall.
2. While holding the mounting plate with one hand, draw
circles on the wall at holes A, B, C and D. Four holes must
be used for mounting. If the holes are not used, the
installation will not be secure. Installer must use these
holes for proper installation. Use toggle bolts through these
holes unless one of them lines up with a stud. Use a wood
screw for studs.
NOTE: Draw a fifth circle inside area E, through one of the
bottom holes to match the location of a stud. For wall-
vented: The oven requires a rear wall cutout opening
for the rear wall duct and the exhaust adapter must be
attached to the mounting plate. See the next page on
how to prepare the rear wall cutout opening and the
exhaust adapter/mounting plate for wall-vented.
3. Drill holes on the circles. If there is a stud, drill a 3/16 hole
for lag screws. If there is no stud, drill a 5/8 hole for toggle
bolts. Make sure to use at least 1 lag screw in a stud, and
4 toggle bolts in the drywall or the plaster.
4. Attach the plate to the wall. To use spring toggle head
bolts: Remove the toggle wings from the bolts. Insert the
bolts into the mounting plate and replace the spring toggle
head to 3/4 past the bolt ends. Insert the spring toggle
head into the holes in the wall to mount the plate. You may
pull forward on the plate to help in tightening the toggle
bolts. Tighten all bolts.
Space More Than Wall Thickness
I Toggle Wings
Mounting H!
_I _ tll
Plate"',_I i: ,, Toggle BoltH:_. ,
I J;', __
ill- .-_wa, I:1
Figure 29
3/16 Hole on Studs
5/8 Hole on Dry wall Only
Minimum 66" I L_
From the Floor
_ For Wall-
Vented Only
Draw Dries
i on Studs i
i Mounting
Plate _ Draw
Center Line
O_ i CenerLne _ Z
• _L . .................................................... o
o ........ o
t ' -[] ' t
Support Tab Support Tab
(1 piece mounting plate)
3/16 Hole on Studs
5/8 Hole on Dry wall Only
_ ,_lMinimum66" I h_
/ I Draw Lines
i / on Studs II _
Draw
't
Support Tab Support Tab
(3 pieces mounting plate)
Figure 28
-14-