Table of Contents
Advertisement
3
The pulsator rotates for
Water will be
8 seconds to detect the
supplied for 2
laundry load.
minutes after the
Then the WATER
start of the wash to
LEVEL
supplement the
will be shown and
water the laundry
water will be supplied.
has absorbed.
4
4
4
4
Close the lid
5
When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes off
automatically.
6
6
6
6
Finish
6
If water is already in the tub, or
putting wet laundry into the tub
before starting will increase the
WATER LEVEL.
With lightweight bulky loads,
WATER LEVEL can be set low.
Changes to Water Temperature
(refer to page 15) and wash level are
possible during operation.
7
Before starting to wash, make sure that
7
the laundry is washable.
Washing with HOT water may
damage the laundry.
Ensure that the load is under 2kg.
When setting the WATER LEVEL
7
manually, do not set to Medium to
prevent damage to laundry.
Washing with HOT water may
damage the laundry .
Ensure that the load is under 2kg.
In order to avoid damage to laundry,
the spin cycle may appear slow. This
also avoids wrinkles and clothing may
still contain some water. This is
normal.
7
Caution & Note
17
Advertisement
Table of Contents
