Lenovo ThinkCentre 8700 User Manual page 47

4. Remove the plastic panel in the bezel for bay 2 by squeezing the plastic tabs
that secure the panel on the inside of the bezel.
5. If you are installing any type of drive other than a serial ATA hard drive, make
sure the drive that you are installing is set correctly as either a master or a
slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
If you are installing an optical drive or a parallel ATA hard disk drive, set it as
a master device. Refer to the documentation that comes with your drive for
master/slave jumper information.
6. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to
3.5-inch
7. Install the drive into the bay.
8. Install the front bezel by aligning the plastic tabs on the side of the bezel with
the corresponding holes in the chassis until the bezel snaps into position.
9. Continue at "Connecting drives" on page 32.
Chapter 3. Installing options
31