Programmes; Washing; Individual Settings; Programme Selector For Switching The - Bosch WAS28462GB Instruction Manual

Before washing for the first time
Run a wash cycle without any laundry
Sort and load the laundry
Follow the manufacturer's care information.
According to the information on the care labels.
According to type, colour, level of soiling and temperature.
Do not exceed the maximum load
Observe the important information
Close the washing machine door. Take care not to trap items of laundry between the washing
Add detergent and care product
The amount of laundry, level of soiling, water hardness (ask your water supply company) and
On models without an insert for liquid detergent:
Pour liquid detergent into the appropriate dispenser and place in the drum.
During operation, open the detergent drawer with care.
Dilute thick fabric softener and conditioner with water.
This prevents blockages.
Set** and adjust the programme
e selector Start/
Reload
Press
= cold)
model-dependent) or (Rinse hold
mains in the water after the final rinse,
ay panel).
ators:
mme duration or end (- -)
ne door, add laundry page 4, 5
page 9
page 7.
page 9.
Insert items of laundry of varying sizes.
machine door and the rubber seal.
Measure according to:
manufacturer's instructions.
1
**If the symbol is lit in the display
panel, the childlock is active
Deactivate it, page 5.
Additional functions and options buttons
Individual settings, page 5
2
Start/Reload

Programme selector for switching the

machine on and off and for selecting

the programme. Can be turned in
either direction.

All buttons are sensitive and need only

to be touched lightly. If you press and
hold the (Finished in) option button,

the appliance automatically runs

through the settings options.

Washing

Detergent drawer
with compartments I, II,
Washing machine door
Control panel
Washing machine
door handle
Service flap
Washing
3
Switch off
Turn the programme selector to Off.
Turn off the tap
Not required for AquaStop models
Refer to Installation instructions.
Remove the laundry
Open the washing machine door and remove the laundry.
If (Rinse hold = no final spin) is active: turn the programme selector
to Drain or Spin . Select the spin speed if necessary.
Press Start/Reload.
– Remove any foreign objects - risk of rusting.
– Leave the washing machine door and detergent drawer open
so that any residual water can dry away.
End of programme when ...
... the Start/Reload button is off and -
display panel.
If the display panel lighting is off, press any button
Energy-saving mode, page 5.
Cancel the programme
3
Programmes at high temperatures:
– To cool the laundry: Select Rinse .
– Press Start/Reload.
Programmes at lower temperatures:
– Select Spin or Drain .
Start/Reload.
– Press
Change the programme if...
... you have selected the wrong programme by mistake:
– Reselect the preogramme.
– Press Start/Reload. The new programme starts from the
beginning.
Add laundry when ...
... Start/Reload is pressed and in the display panel both
symbols are then lit.
If is lit, the washing machine door cannot be opened.
Select the Start/Reload button.
- appears in the
page 5
+
4