Replacing Uv Bulb - Brookstone BWM-211D Instruction Manual

Germ-free humidifier
Table of Contents

Advertisement

RePlacInG Uv bUlb

If the REPLACE UV BULB WHEN LIT signal light is illuminated during normal use,
the bulb must be replaced with the same special 3 . 5 W bulb, EUV-13B . The UV bulb
will operate at maximum output for approximately 2,000 hours . The UV bulb may operate
longer than 2,000 hours but at a reduced output . To keep your humidifier operating at
maximum efficiency it is recommended that the UV bulb be replaced after 2,000 hours
of use .
1 . If the REPLACE UV BULB indicator illuminates during normal use, it is time
to change the UV bulb, which is a special 3 . 5 W bulb .
2 . Press POWER/MODE switch to the OFF position, unplug it and allow
it to cool .
3 . Remove the WATER TANK from the base of the humidifier .
4 . Place the base of the humidifier over the sink and tilt the unit to remove
any remaining water .
5 . Carefully turn the base of the humidifier over and place it upside down
on a flat, level surface . You will see a door that is closed with a screw(s) .
6 . Using a Phillips head screwdriver, carefully turn the screw(s) counterclockwise
until the screw(s) separate from the door .
7 .
Open the door . The UV lightbulb will be visible .
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents