Download Print this page

Kenmore 79032353000 Installation Instructions Manual page 8

Gas cooktop

Advertisement

Available languages

Available languages

6. Electrical
Requirements
120 volt, 60 Hertz, properly
grounded
branch
circuit
protected
by a 15 amp circuit
breaker
or time delay
fuse. Do not use an extension
cord with
this cooktop.
Grounding
Instructions
iMPORTANT
Please read carefully.
For personal
safety,
this appilance
must be properly
grounded.
The power cord of this appliance
is equipped
with a
3-prong
(grounding)
plug which
mates with a standard
3-prong
grounding
wall receptacle
(see Figure 9) to
minimize
the possibility
of electric
shock hazard
from
the appliance.
The wall
receptacle
and circuit
should
be checked
by
a qualified
electrician
to make sure the receptacle
is
properly
grounded.
Where
a standard
2-prong
wall receptacle
is installed,
it is the personal
responsibility
and obligation
of the
consumer
to have it replaced
by a properly
grounded
3-prong
wall receptacle.
Preferred
Method
Grounding
type
wail
receptacle
not, under
circumstances,
cut, remove,
or bypass
the
grounding
prong.
7. Check Operation
Refer to the Use and Care Guide packaged
with the
cooktop
for operating
instructions
and for care and
cleaning
of your cooktop.
1.
Remove
foam
caps.
2.
Turn on Electrical
Power and Open Main Shutoff
Gas Valve
.
Check the igniters
Operation
of electric
igniters should
be checked
after
cooktop
and supply
line connectors
have been
carefully
checked
for leaks and the cooktop
has
been connected
to electric
power.
To operate
the surface
burner:
A.
Push in and turn a surface
burner
knob to the
LITE position.
You will hear a small ticking
noise;
this is the sound of the electric
ignitor which
lights the burner.
B.
After the burner
lights, turn to the desired
flame
size. The controls
do not have to be set at a
particular
mark. Use the marks as a guide
and
adjust
the flame
as needed.
Power supply cord with
3-prong
grounding
plug.
Figure 9
Do not, under any circumstances,
cut or remove the
third
(ground)
prong from the power cord.
_
Disconnect
electrical
supply
cord from
wall receptacle
before
servicing
cooktop.

Advertisement

loading