Installation Diagram - Mitsubishi Electric MSZ-FD09NA Installation Manual

1-4. INSTALLATION DIAGRAM
ACCESSORIES
Check the following parts before installation.
<Indoor unit>
(1) Installation plate 1
Attachment screws for the installa-
(2) tion plate 5
4x25mm
(3) Remote controller holder 1
Screws for the remote controller
(4) holder 2
3.5 x 16 mm (Black)
(5) Battery (AAA) for (6) 2
(6) Wireless remote controller 1
(7) Felt tape (For left or left-rear piping) 1
(8) Anti-Allergy Enzyme Filter 1
(9) Platinum deodorizing filter 1
FIELD-SUPPLIED PARTS
(A) Indoor/outdoor unit connecting wire* 1
(B) Extension pipe 1
(C) Wall hole sleeve 1
(D) Wall hole cover 1
(E) Pipe attachment strap 2 to 5
(F) Screw for (E) 4 x 20 mm 2 to 5
(G) Piping tape 1
(H) Putty 1
Drain hose
(or soft PVC hose, 19/32 in. [15 mm] 2 to 5
(I) inner diameter or hard PVC pipe
VP16)
(J) Refrigerant oil 1
(K) Power supply cord 1
* Note:
Place indoortoutdoor unit connecting wire (A)
and power supply cord (K) at least 3 ft. (1 m)
away from the TV antenna wire.
f
Use the wall hole sleeve
(C) to prevent indoortout-
door connecting wire (A)
from contacting metal
parts in the wall and to
protect the wiring from
rodents.
_[_,_JWall hole cover (D)
I
indoor unit _Seal thewall hole ]
Wal_ hole' VfJ// "m
sleeve (C)_ I [ I Attach!hepipe.to |
• ' _/_j_-_ wall with pipe at- |
r//tt_ [ tachrnent strap (E). I
Cut off the Pipe attachment
extra length. _strap (E)
Attachment screw (F)
_"After the leak test, apply insulating mate- ]
Lrial
tightly so that there is no gap. J
When the piping is to be attached to a wall
comprised of tin plate or metal netting, use
chemically treated wooden piece 25/32 in.
(20 ram) or thicker between the wall and
the piping, or wrap insulation vinyl tape 7
to 8 turns around the piping.
To use existing piping, perform COOL
operation for 30 minutes and pump down
before removing the old air conditioner.
Remake flare according to the dimension
for new refrigerant.
Open two sides of
left, right, or rear
side.
Units should be installed by licensed contractor
accord ng to oca code requ rements.
Basically open 4 in.
(100 mm) or more
without any obstruction
in front and on both
sides of the unit.
4 in.
(100 ram)
or more
Unit: inch
31-1/2
5_ 19-11/16 _L_
43- Air inlet
42. _r__/16
f Air outlet
2-3/8 × 13/16 stot
Unit: mm
800
500 1
_ "_ Ai_r_nlet 40 _
2 10 x 21 slot Air outlet