Advertisement
INSTALLATION
MANUAL
• Remove
all packing
Sealing
materials
from inside
the Microwave Drawer.
DO NOT
REMOVE
THE
WAVEGUIDE
COVER,
which
is
located on the top of the
Microwave
Drawer.
• Remove
the feature
sticker, if there is one.
_
Sealing
Surface
Check
the drawer
for
Oven
any damage,
such as
Cavity
misaligned
or bent
drawer,
damaged
drawer seals and sealing surfaces, broken or loose Microwave
Drawer guides and dents inside the cavity or on the front
side of the drawer. If there is any damage,
do not operate
the Microwave
Drawer and contact 3our dealer or a SHARP
AUTHORIZED
SERVICER.
_To
reduce
the risk of tipping, the Microwave
Drawer
must
be secured
by a properly
installed
Anti-Tip
block.
• This Microwave
Drawer must be electrically
grounded
in
accordance
with local codes.
• Make sure the wall coverings and the cabinets around the
Microwave Drawer can withstand the heat generated by the
Microwave
Drawer.
Never leave children alone or unattended
in
the area where a Microwave
Drawer
is in use. Never leave the
drawer open when the microwave
is unattended.
_
Stepping,
leaning
or sitting
on the drawer
may result in serious injuries and can also cause damage to the
Microwave
Drawer.
• Do not use the Microwave Drawer as a storage space.
This creates a potentially hazardous situation.
• Check that the time-ol2day
is in the display.
If not, touch
Stop/Clear
to prevent unintended
use.
• Read all of the Installation
Manual
before installing
the
Microwave
Drawer.
• Remove all packing material before connecting the electrical
supply.
•
Observe all governing
codes and ordinances.
•
Be sure to leave these instructions
with the consumer.
Keep
this manual
with your Operation
Manual
for future
reference.
• As when using any microwave oven generating heat, there are
certain safety precautions you should follow. These are listed
in the Operation
Manual. Read all and tollow carefully.
• Be sure your Microwave Drawer is installed and grounded
properly by a qualified iustaller or service technician.
I_'_'_]_
If the information
in this manual is not followed
exactly, a fire or electrical
shock may result that could cause
property damage, personal injury or death.
Dimensions
that are shown in Figures
1 and 2 must be used.
Given
dimensions
provide
minimum
clearance.
Locate
electrical
_mtlet in the shaded area in the upper left-hand
corner of the cutout.
Contact surface must be solid and level. Pay special attention
to the floor on which the Microwave
Drawer will sit. The
floor of the opening
should
be constructed
of plywood
strong enough to support the weight of the oven (about 100
pounds).
Check
location
where
the Microwave
Drawer
will be
installed for proper electrical
supply.
Your oven can be built into a cabinet or wall by itself or
under a specific electric wall oven listed below.
Electrolux
E3flEW75DSSI
Kitchen Aid
KEBCI07KBLO
Frigidaire
PLEB3flsgccc
Viking
DES0100
Wolf
S030F/S
Be sure that the clearance of the floor between the wall oven
and the microwave drawer is a mininmm
of 2-inches.
For updates of approved appliances that can be used adjacent
to the Microwave
Drawer go to www.sharpusa.com.
The microwave interior will easily accommodate
a 9" x 13"
oNong dish or a bag of microwave popcorn.
2
Advertisement
