Front Panel Controls - Harman Kardon AVR 505 LIMITED EDITION Owner's Manual

Front Panel Controls

Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Selector Buttons
Tone Mode
Surround Mode Group Selector
Tuning
Tuner Band Selector
Preset Stations Selector
Main Power Switch: Press this button to
apply power to the AVR. When the switch is
pressed in, the unit is placed in a Standby
mode, as indicated by the orange LED
button MUST be pressed in to operate the unit.
To turn the unit off completely and prevent the
use of the remote control, this switch should be
pressed until it pops out from the front panel
so that the word "OFF" may be read at the top
of the switch.
NOTE: This switch is normally left in the "ON"
position.
DIGITAL LOGIC 7
PRO LOGIC
3 STEREO DSP
5 CH. STEREO
SURR. OFF
Surr. Select
Input Source Selector
RDS Select Button
Surround Mode Selector
Surround Mode Indicators
Remote Sensor Window
Bass Control
Balance Control
Treble Control
Volume Control
Set Button
System Power Control: When the Main
Power Switch is "ON, " press this button to
turn on the AVR; press it again to turn the unit
. This off (to Standby). Note that the Power
Indicator will turn blue when the unit is on.
Power Indicator: This LED will be illumi-
nated in orange when the unit is in the Standby
mode to signal that the unit is ready to be
turned on. When the unit is in operation, the
indicator will turn blue.
Headphone Jack: This jack may be used to
listen to the AVR's output through a pair of
headphones. Be certain that the headphones
have a standard 6.3 mm stereo phone plug.
Note that the speakers will automatically be
turned off when the headphones are connected.
VID 1 DVD
VID 2 CD
VID 3 FMAM
TAPE
6 CH
RDS
Coaxial 3
Input Indicators
Delay
Digital Input Selector
Main Information Display
Channel Select Button
Speaker Select Button
Digital Optical 3 Input
Digital Coax 3 Input
Video 3 input jacks
Speaker/Channel Input Indicator
Selector Buttons: When you are establish-
ing the AVR's configuration settings, use these
buttons to select from the choices available, as
shown in the Main Information Display
Tone Mode: Pressing this button enables or
disables the Balance, Bass and Treble tone con-
trols. When the button is pressed so that the
words appear in the Main
TONE I N
Information Display , the settings of the
Bass and Treble controls and of the
Balance control will affect the output sig-
nals. When the button is pressed so that the
words appear in the Main
TONE OUT
Information Display , the output signal
will be "flat, " without any balance, bass or treble
alteration.
FRONT PANEL CONTROLS 5
.