Operation - American DJ Revo II User Instructions

Revo II™
and press Enter.
LED -
With this function you can switch the lamp on or off
via the control board.
1. Tap the either the MENU button until "LED" is displayed,
press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to switch on the LED, or "OFF" to
switch off the LED.
3. Press ENTER to confirm and exit.
I DSP -
This function will reverse the display 180º.
1. Tap the either the MENU button until "I DSP" is displayed,
press ENTER.
2. Press the UP button to select "DSP i" to activate this function,
or "I DSP" to deactivate this function.
3. Press ENTER to confirm.
FHRS
- With this function you can display the running time
of the unit.
1. Tap the either the MENU button until "FHRS" is displayed,
press ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
VER
- Use this function to display the Software version of
the unit.
1. Tap the either the MENU button until "VER" is displayed,
press ENTER.
2. The display will show the software version.
American DJ - www.americandj.com - Revo II™ Instruction Manual Page 9
®
System Menu Revo II™
Operating Modes: The Revo II™ can operate in three different
modes. This next section will detail the differences in the oper-
ating modes.
• Stand alone mode -
The unit will react to sound, chasing through the built-in programs.
• Master/Slave mode -
You can daisy chain up to 16 units together to get a synchronized
light show without the need of an external controller. The units will
react to sound chasing through the several built-in programs.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
Designer.
Universal DMX Control:
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Revo II™ uses four DMX channels, depending on what mode
you are in. See page 13 for detailed description of the DMX traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-7 as well as the set-up specifications that are
included with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 8 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Stand-Alone Operation (Sound Active Show Mode):
allows a single unit or several units linked together, to run to the beat
of the music.
1. Tap the MENU button until
ENTER.
2.
Tap the UP or DOWN buttonS until you find your desired show,
and press ENTER.
™
This function allows you to use a Elation
"SHOW" is displayed, and press
American DJ - www.americandj.com - Revo II™ Instruction Manual Page 10
®

Operation

Show
®
®
This mode