Advertisement
if codes permit
and a separate ground wire is used, it
is recommended
that a qualified
eJectrician
determine
that the ground path and wire gauge are
in accordance
with
iota[ codes.
Do Not ground to a gas pipe.
Check with a qua[ified
electrician
if you are not sure
range is properJy grounded.
Do Not have a fuse in the neutral
or ground circuit.
This range must be connected
to a grounded
meta[,
permanent
wiring
system.
Range must be connected to the proper electrical
voltage and frequency as specified on the
model/serial rating plate. (The model/serial rating
plate is located on the oven door or on the oven
frame.)
[_ Models rated from 11.8kW to 13.3 kW at 240
volts (8.9 kW to 10.0 kW at 208 volts) require a
separate 40-ampere circuit.
[_A timeodelay fuse or circuit breaker is
recommended.
[_ Connect directly to the fused disconnect (or
circuit breaker box) through flexible, armored
or non-metallic sheathed, copper cable (with
ground wire).
[_ Flexible armored cable from appliance should
be connected directly to junction box.
[_ Fuse both sides of the line.
[_A U.L.-[isted conduit connector must be
provided at the junction box.
[_ Do Not cut the conduit.
Wire sizes and connections must conform with the
rating of the appliance and to the requirements of
the National Electrical Code, ANSi/NFPA 70 -- latest
edition (_* See Page 1) and ail local codes and
ordinances.
if the house has aluminum wiring, follow the
procedure below.
a.) Connect the aluminum wiring to the copper wire
using special connectors designed and
Underwriters Laboratories-listed for joining
copper to aluminum. Follow the electrical
connector manufacturer's recommended
procedure.
b.) Aluminum/copper
connection must conform
with local codes and industry-accepted wiring
practice.
_
onnect
power
supply
cable.
ReR3ove_
_
shipping
feet.
Replace
oven
door.
Preparation
Excessive Weight Hazard
Use two or more people to move and
install range.
Failure to do so can result in back or
other injury.
important: Use both hands to remove oven door.
Do Not use handle or any portion of the front
frame or trim for tilting.
Before moving range across floor, check that
range is on shipping base or slide range onto
cardboard or hardboard.
Do Not remove shipping feet at the front tower
corners of range.
tm
Turn power supph/
off. Move range dose to
final position.
, Remove and discard
shipping materials, tape
and protective film from
the range. Do Not
remove shipping base
or shipping feet at the
front lower corners of
Do Not
remove
shipping
feet.
range. The shipping feet wi[[ protect the
tower range trim until range is inserted into
cabinet.
, Remove and set aside oven racks and other
parts from inside oven.
latch on the
hinge
in
locked
position
=
door
free
to open
and
close
latch
on the
hinge
in unlocked
position
= door
ready
for
removal
m Completely open oven door. In both back
corners of the door you wi[[ see door latches in the
locked position. Rotate both latches forward to the
unlocked position.
Grasp outside edges of door with both hands.
• Begin closing door, at the moment the door
stops closing, lift and pull door toward you.
• Set door aside on a protective surface.
Pull top of trim
down.
3m
Remove trim screws attaching right and
[eft side trim to range. Grasp the bottom end of
trim and pull away from range. Slide top end of
trim downward to remove trim from range.Take
care not to scratch other surfaces with ends of
trim. Set trim and screws aside on protected
surface.
Page 2
Advertisement
