Table of Contents
Advertisement
User Manual
DMX Recei v er w i th 3 Channel PW M Dr i v er
6 M ay 201 3
Specifications
Physical
Dimensions
Weight
I nputs
Voltage
Current
Fuse
Communications
DMX Load
Outp uts
Outputs
Current Per Channel
Installation
Co nnections
Figure 2 shows the
connections on the LDMX-
PWM-3. For standard
operation, simply connect
24V to the power connector,
the led fittings to the PWM
outputs and either the Colour
Theme Controller or a DMX
source to control the light
levels.
Operation
The LDMX-PWM-3 has a single 24VDC power supply. Once it is connected, the red
power LED shown in Figure 2 will come on. If the unit is receiving good
communications, the green DMX activity LED will also be on.
Setting Address
The DMX address is set using the first 9 switches of the DMX address switch. The
address is set as a binary number (with switch 1 the LSB, Appendix A lists addresses
and their corresponding switch settings). As the unit is a 3 channel receiver, it will
respond to data in the set address, and the following 2 addresses in the DMX data
stream. Therefore, the address should not be set to over 510. Note: that to use a
Colour Theme Controller, the address must be set to 1.
d i g i l i n . c o m . a u
138 x 63 x 31
115
12 – 24
6
DMX or Colour Theme Controller
0.25
3 Channels Common Anode (low side)
PWM
2
DMX Address
1 2 3 4 5 6 7 8 9 10
Power
DMX
Figure 2 Connection diagram.
U n i t s
mm
g
U n i t s
VDC
A
Standard Devices
U n i t s
A
P a g e 3 o f 9
Advertisement
Table of Contents
