Table of Contents
Advertisement
Audio System
To Pause a Disc
To pause a disc, press the
corresponding number of the
current disc on the appropriate side
of the preset bars. To play the disc
again, press the preset bar again.
To Stop Playing a Disc
If you turn the system off while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition
switch, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off.
To take the system out of CD mode,
press the AM or FM, CD/AUX, or
button. To return to CD
mode, press the CD/AUX or CD
(Canadian model) button. The
system will continue at the same
point that it left off.
192
Removing CDs from the Changer
To remove the disc that is currently
playing, press and release the eject
(
) button. You will see
''EJECT'' on the center display.
When you remove the disc from the
slot, the system begins the load
sequence so you can load another
disc in that position. If you do not
load another CD within 10 seconds,
the system selects the previous
mode [AM, FM1, FM2, or XM Radio
(U.S. models)].
If you do not remove the CD from
the slot, the system will reload the
CD after 10 seconds and put the CD
changer in pause mode. To begin
playing the CD, press the CD/AUX
or CD (Canadian model) button.
To remove a different CD from the
changer, select it with the
appropriate side of the preset bar.
When that CD begins playing, press
the eject button.
Press and hold the eject button until
you hear a beep to remove all the
discs from the changer.
You can also eject discs when the
ignition switch is off by pressing the
eject button. The disc that was last
selected is ejected first. You can
eject the rest of the discs one at a
time.
Protecting Discs
For information on how to handle
and protect compact discs, see page
233
.
CD Changer Error Messages
For information, see page
234
Adjusting the Sound
For information, see page
196
.
.
Advertisement
Chapters
Table of Contents
