Changing The Light Bulb; Replacing The Slide Plate - Singer 8007; 8019; 8002 Instruction Book

*
Apply three drops of oil to all places indi-
If Machine Is To Be Stored
cated.
* Occasionally apply one drop of oil to all
other rotating or moving machine connec-
• Disconnect power-line plug from electric
tions to ensure freedom of movement,
outlet.
After oiling, replace face plate and-arm top
cover. Sew a few lines of stitching on a scrap
*
Clean all exposed parts and area behind
of material to remove excess oil,
face plate
CAUTION: Donotattempttoadjustthemotor
, Swab all exposed metal parts and parts
belt. Contact your nearest Service Centre
behind face plate with oil to protect
should any adjustment be required.
against rust.
Changing The Light Bulb
CAUTION: Disconnect the power-line plug
r
.
from the socket outlet before changing light
bulb.
This machine is designed to use a 15 watt
maximum bayonet base bulb only.
Remove face plate, as instructed on page 51.
1. Removing Bulb: Press bulb into socket and
at the same time turn bulb in direction
shown to unlock bulb pin (do not attempt
to unscrew the light bulb).
2, Replacing Bulb: Press new bulb into soc-
ket. with bulb pin entering slot of socket,
and turn it in direction shown to lock bulb
in position. Replace face plate.
Replacing The Slide Plate
You will not have any occasion to remove the
slide plate However. if it should accidentally
become disengaged from the machine, it is
2
easily replaced.
* Raise the presser foot and makesure needle
is in its highest position.
" Place slide plate in slide way with the front
edge close to, but not covering, the retain-
ing spring (as shown).
A
* With a small screwdriver, lift each end of the
spring A into each of the side grooves on the
underside of the plate
* Draw the plate gently toward you and fully
engage the spring
* Close slide plate.
52