Using The Video Card; Configuring The Video Display; 3Dlabs Configuration Tab - 3Dlabs The Wildcat 4110 PRO User Manual

Graphics accelerator

Table of Contents

3 Using the Video Card

This chapter contains instructions for configuring the video display and enabling the stereo display.

NOTE:

If you ordered this video card with a system, it was configured for use prior to shipment. The

following instructions apply only if you purchased the card as an upgrade or add-on.

Once the drivers are installed properly, the Display Properties dialog box will have two additional tabs:

3Dlabs Configuration and 3Dlabs Monitor.

Wildcat Configuration Tab

To use the Wildcat Configuration tab:

1. Make sure you are logged into the non-VGA version of Windows NT 4.0 or Windows

2000. Refer to Windows NT 4.0 or Windows 2000 documentation or online Help for

instructions, if necessary.

2. Close any open applications.

3. From the operating system Start menu, go to Settings/Control Panel/Display. In Windows

NT 4.0, click the 3Dlabs Configuration tab if it is not already displayed. In Windows

2000 follow the same path; then click the Settings tab and then Advanced. Click the

3Dlabs Configuration tab if it is not already displayed (see Figure 6).

4. On the Wildcat Configuration tab:

Click Hardware Info to view the current hardware settings.

Click View Config to view your current display configuration.

Click Config Wizard to activate a step-by-step interface that will help you modify

your current display configuration or create a new one. On the Wildcat Configuration

Wizard, click Next and follow the prompts to create a new configuration, or modify

or delete an existing one.

Table of Contents