Subscribe to Our Youtube Channel
Related Manuals for Albion TCT50
Summary of Contents for Albion TCT50
- Page 1 OPERATING MANUAL AND USER GUIDE TCT50 & TCT100 www.albionamps.com TCT 50.indd 2011-5-5 18:32:00...
- Page 2 TCT 50.indd 2011-5-5 18:32:00...
-
Page 3: Table Of Contents
Contents Important Safety Instructions ..................1 Important Warnings ....................... 2 Designer's Introduction ....................3 Outline Specification ..................... 3 TCT50 & TCT100 Features and Controls ..............5 Rear Panel ........................7 Specification ........................8 TCT 50.indd 2011-5-5 18:32:01... -
Page 4: Important Safety Instructions
OPERATING MANUAL AND USER GUIDE Important Safety Instructions 1. Read these instructions – All the safety and operating instructions should be read before this product is operated. 2. Keep these instructions – The safety and operating 13. Unplug the apparatus during lightning storms or when instructions should be retained for future reference. unused for long periods of time. 3. Heed all warnings – All warnings on the appliance 14. -
Page 5: Important Warnings
This is quite normal by a SKILLED PERSON. and will be within safe operational limits. These limits are set by various countries safety approvals committees, and we at Albion Musical Instruments Important Warnings design, build, test, and have approved our products to these international standards. I.e. CE, UL, CSA, CB, ETL etc. -
Page 6: Designer's Introduction
4 x EL34) and utilise the same amplifier chassis but the time honoured interactive passive system historically with a different number of output EL34 valves and required used on most guitar amps, our design is somewhat wider transformers, biasing etc. The TCT50C (2 x 12” combo, ranging than most others. For instance the MIDDLE 2 x EL34) has the same chassis and circuit as the TCT50 control has a much wider range than normal and will give TCT 50.indd 2011-5-5 18:32:02... - Page 7 The power amp section can be switched between two feedback networks. Loose gives a raw, open, vintage style to the sound with lots of player feel and tactile response. Tight gives a much tighter modern response to the sound and feel. The output section can also be run at 33% (approx 16.5 watts for TCT50, and 33watts for TCT100) of its total output power for those situations when flat out really is “too loud”! The TCT50C combo comes complete with two of our own designed and built Albion loudspeakers. TCT 50.indd...
-
Page 8: Tct50 & Tct100 Features And Controls
LOOP BYPASS HIGH ROUTE RETURN SEND LEVEL TCT50 & 100 Features and Controls FOOTSWITCH WARNING! DO NOT USE WITHOUT CONNECTING LOUDSPEAKER LOAD TO AMPLIFIER AND MATCHING SERIES EFFECTS LOOP CONNECTOR OUTPUT IMPEDANCE TO SPEAKER IMPEDANCE. 16ohm OUT = 1 x 16ohm LS, 8ohm OUT = 1 x 8ohm OR 2 x 16ohm LS... - Page 9 “LOOSE” (low amount of feedback, switch of full power (approx. 16.5 Watts TCT50, or 33 Watts out). Not to get too technical these two settings can either TCT100) allowing great low volume performance without give a flatter tightly controlled response between the compromise. Coupled with the Master Output control,...
-
Page 10: Rear Panel
CONNECTING THE EARTH (GROUND) WIRE. CONNECTING THE EARTH (GROUND) WIRE. 300Watt TUBE PRE/BIPOLAR POWER BASS AMPLFIER FOOTSWITCH CONNECTOR – the supplied Albion In the case of the mains fuse blowing, this can be changed LOUDSPEAKER OUTPUT SOCKETS WARNING! DO NOT USE WITHOUT CONNECTING LOUDSPEAKER LOAD TO AMPLIFIER PARALLEL CONNECTED SOCKETS... -
Page 11: Specification
Mains Fuse = 230V 50 Hz supply = T2.5AL (time lag) 250V rated 20mm glass fuse AMI 3 WAY FOOT-PEDAL – the 3 way foot-pedal supplied Mains Fuse = 240V 50/60 Hz supply = T2.5AL (time lag) with your TCT50/100 amplifier has a couple of features that 250V rated 20mm glass fuse you may want to be made aware of. Firstly the supplied 5 way DIN cable can be replaced if required by any 5 way Warning! Where fuses specified are rated at 250V please DIN lead –... - Page 12 OPERATING MANUAL AND USER GUIDE IAG House, Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE29 6XU, England www.albionamps.com The information in this brochure is subject to change without notice. All rights reserved © 2010 Albion. Albion is a member of the IAG Group. TCT 50.indd 2011-5-5 18:32:32...
Need help?
Do you have a question about the TCT50 and is the answer not in the manual?
Questions and answers