Table of Contents
Related Manuals for Nothern Industrial tools 1555811
Summary of Contents for Nothern Industrial tools 1555811
- Page 1 7" TILE CUTTER OWNER'S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item # 1555811...
-
Page 2: Specifications
Introduction: The tile cutting machine is designed to perform cutting jobs on small and medium tiles (floor and wall tiles made of ceramic and similar material) which suit the machine's size. It is intended in particular for use by DIY enthusiasts and craftsmen. -
Page 3: General Safety Rules
General Safety Rules: WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. WARNING! The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. - Page 4 • Dress properly. Do not wear loose clothing of jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. Air vents often cover moving parts and should be avoided. •...
-
Page 5: Operation
Assembly Instructions: 1. Insert the adjusting bracket (13) as per drawing (A) but do not tighten screws 2. Fit the diamond cutting wheel as per drawing (C) • Insert the flange (22) in the drive shaft as shown in the drawing •... - Page 6 Explode Drawing and Parts List:...
- Page 7 Part No. Description Part No. Description Hex nut M5 Plate Spring lockwasher M5 Nut, table tilt Falt washer M5 Protecting board, lower Blade cover, plastic Bolt M6X12 Bracket, blade guard Hex nut, M6 Bolt M5X30 Motor assy. able Cover,motor Rubber cap, rip fence Screw,motor cover, M4X6 Bracket, rip fence Tooth washer 4...
Need help?
Do you have a question about the 1555811 and is the answer not in the manual?
Questions and answers