Subscribe to Our Youtube Channel
Summary of Contents for AJA RD10MD2
- Page 1 RD10MD2 Dual HD to SD Down Converter R-series Card Module Published: 6/30/10 Installation and Operation Guide B e c a u s e m a t t e r s .
-
Page 2: Contacting Support
Video parts or supplies, or d) to service a product that has been modified or integrated with other products when the effect of such a modification or integration increases the time or difficulty of servicing the product. - Page 3 AJA RH10MD2 Dual HD Down Converter User Manual Introduction The RD10MD2 is a 10-bit broadcast-quality Dual channel HD down converter. Channels 1 and 2 are fully independent. Channel 1 has 1 re-clocked HD/SD-SDI outputs and channel 2 also has 1 re-clocked HD/SD-SDI output. Both Channel 1 and 2 have 2 down converted outputs, which can be independently configured...
-
Page 4: Block Diagram
RD10MD2 Rear Panel FR1 and FR2 BNC Connector Assignments, RD10MD2 Card Module When the RD10MD2 module is installed in an AJA FR1 or FR2 frame, a corresponding group of 9 BNCs on the rear panel then provide I/O for the module. -
Page 5: User Controls
AJA RH10MD2 Dual HD Down Converter User Manual User Controls The user interface for configuring the RD10MD2 and LEDs selecting output formats is a pair of dipswitches at the front of the card and several jumpers in the middle and at the back of the card (see J2, J3, J5, and J6 in the photo below). - Page 6 DIP Switch There is a separate 6-position dipswitch for each channel that controls a number of configuration settings for the RD10MD2 card. The top dipswitch controls channel 1 Settings and the one beneath it, channel 2. Settings are the same for both dipswitches. These are described in the following table.
-
Page 7: Jumper Settings
AJA RH10MD2 Dual HD Down Converter User Manual Jumper Settings SDI ANA Examples: Jumper 1 Selects SDI Jumper 2 Selects Analog Composite Jumpers J5 & J6 select SDI or Analog Output. J5 configures Channel 1 Output J6 configures Channel 2 Output... -
Page 8: Installation
Installation Typically, RD10MD2 installation consists of the following: 1. disconnect power from the frame (remove line cord) 2. remove the FR1/FR2 front panel 3. install RD10MD2 card module 4. replace the FR1/FR2 front panel 5. apply power to the frame by connecting a north american-style power cord... - Page 9 AJA RH10MD2 Dual HD Down Converter User Manual Appendix A: Safety & Compliance Federal Communications Commission (FCC) Compliance Notices Class A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable Interference protection against harmful interference in a commercial installation.
-
Page 10: Korea Kcc Compliance Statement
Declaration of Marking by this symbol indicates compliance with the Essential Requirements of the EMC Directive of the European Union 2004/108/EC. Conformity This equipment meets the following conformance standards: Safety: CB- IEC 60065:2001 + A1:2005 NRTL - UL 60065:2003 R11.06, CSA C22.2 NO. 60065:2003 + A1:06 GS - EN 60065:2002 + A1 Additional licenses issued for specific countries available on request. -
Page 11: Taiwan Compliance Statement
AJA RH10MD2 Dual HD Down Converter User Manual Taiwan Compliance Statement This is a Class A product based on the standard of the Bureau of Standards, Metrology and Inspection (BSMI) CNS 13438, Class A. Japanese Compliance Statement 1. Class A ITE −... - Page 12 Warning! Do not use this device near water and clean only with a dry cloth. Avertissement! N'utilisez pas cet appareil près de l'eau et nettoyez-le seulement avec un tissu sec.. Warnung! Das Gerät nicht in der Nähe von Wasser verwenden und nur mit einem trockenen Tuch säubern.
- Page 13 AJA RH10MD2 Dual HD Down Converter User Manual Avertissement ! Référez-vous au personnel de service qualifié pour tout entretien. L'entretien est exigé quand l'appareil a été endommagé de quelque manière que ce soit, par exemple lorsque le cordon d'alimentation ou la prise sont endommagés, que du liquide a été versé ou des objets sont tombés dans l'appareil, que l'appareil a été...
- Page 14 ¡Advertencia! Cuando mueva la unidad desenchufe de la red eléctrica el/los cable(s) de la fuente de alimentación CA tipo brick. Advertência! Remova os cabos CA de alimentação brick da rede elétrica ao mover a unidade. Avvertenza! Scollegare il cavo dell’alimentatore quando si sposta l’unità. Warning! Ensure Mains Power is disconnected before installing the FR1 or FR2 frame R- series modules into the frame, or installing and removing options.
- Page 15 AJA RH10MD2 Dual HD Down Converter User Manual Caution! The FR1/FR2 front fan door is heavy and is not hinged. Remove with Caution. Attention ! La porte frontale du ventilateur de FR1/FR2 est lourde et ne repose pas sur des charnières. Retirer avec précaution.
Need help?
Do you have a question about the RD10MD2 and is the answer not in the manual?
Questions and answers