Advertisement
Available languages
Available languages
LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1.
In an area exposed to dripping water or outside weather
4.
conditions. The ambient temperature should never be below
60°F(15.6°C)forproperwasher(deterg
entbreakdown)
5.
operation.
2.
In an area where it will come in contact with curtains or
drapes.
6.
3.
In an area (garage or garage-type building) where gasoline
of other
flammables
are kept or stored
(including
automobiles).
4.
On carpet. Floor MUST be solid with a maximum slope of
1/2 in. per foot (1.27 cm per 30.5 cm). To ensure vibration
7.
or movement does not occur, reinforcement of the floor
may be necessary.
IMPORTANT
MINIMUM INSTALLATION CLEARANCES
When installed in alcove or closet:
Sides, Rear = 0 in. (0 cm/
Top = 0 in. (0 cm)
When installed
in closet:
Front = 1 in. (2.54 cm)
Closet door ventilation required: 2 Iouvered openings each 60
in2(387 cm_), 3 in. (7.6 cm) from top and bottom of door.
UNPACKING
1.
Cut the shipping carton along the dotted line along the
bottom.
Remove the carton.
2.
Using a rug, blanket or piece of cardboard to protect the
floor, lay the washer on it's back.
3.
Remove and save the styrofoam base and shipping plug.
Shipping
Base
Plug
Carefully return the washer to an upright position.
Carefully move the washer to within 4 feet (122cm) of the
final location.
Remove the following from the back panel of the washer:
4 shipping bolts,
4 spacers,
1 metal "P" damp.
Remove the 4 plugs from the literature pack located in the
drum and install them in the holes vacated by the packaging
spacers.
NOTE: If the washer is to be transported at a later date,
the shipping support hardware must be reinstalled
to prevent shipping damage.
_emove:
metal
"P"
4 shipping
bolts,
4 spacers,
4
Advertisement
