Front
Console
Dimensions
Rear Console
Dimensions
electrical
supply on rear of unit,
power
cord length
on gas unit
approximately
59" (150 cm)
1"
L
(2.5 cm)_
under-counter
l
installation
height
[
34 5/8"
(87.9 cm)
to center
of
rear vent
center
line
13 1/2"
_"
height
for
(34.4 cm)
rear vent
i
3 3/4"
--4_t_-"-_
(9.5 cm)
I
I
I
b-
gas supply pipe on
9/16"
rear
of gas unit
(6.5 cm)
T
36"
(91.5 cm)
47 112" (120.7 cm)
to clear open door
m
m
4 3/8"
(11 cm)
opt io_-a I yen
knockout
_
----
27" (68.6 cm)
3 3/4"
(9.5 cm)
electrical
supply on rear of unit,
,__-_-j
power cord length
on gas unit -_
approximately
59" (150 cm)
to center
of
rear
vent
_"
13 1/2"
(34.4 cm)
1"
(2.5 cm)
2 9/16"
(6.5 cm)
43 5/8"
(111 cm)
center
line
height
for
rear vent
l
3 3/4"
(9.5 cm)
_T_
\gas
supply pipe on
rear of gas unit
47 1/2" (120.7 cm)
to clear open door
m
m
4 3/8"
(11 cm)
opti_l
vent
knockout
_
--
m
3 3/4"
(9.5 cm)
27" (68.6 cm)
_ I
Electrical
installation
The following are specific requirements for proper and safe
electrical installation of your dryer. Failure to follow these
instructions can create electrical shock and/or a fire hazard.
- ELECTRICAL SHOCK HAZARD -
, This appliance MUST be properly grounded. Electrical
shock can result if the dryer is not properly grounded. Fol-
low the instructions in this manual for proper grounding.
• Do not use an extension cord with this dryer. Some ex-
tension cords are not designed to withstand the amounts
of electrical current this dryer utilizes and can melt, creat-
ing electrical shock and/or fire hazard. Locate the dryer
within reach of the receptacle for the length power cord
to be purchased, allowing some slack in the cord. Refer
to the pre-installation requirements in this manual for the
proper power cord to be purchased.
- ELECTRICAL SHOCK HAZARD -
• A U.L.-approved strain relief must be installed onto pow-
er cord. If the strain relief is not attached, the cord can be
pulled out of the dryer and can be cut by any movement
of the cord, resulting in electrical shock.
• Do not use an aluminum wired receptacle with a copper
wired power cord and plug (or vice versa). A chemical
reaction occurs between copper and aluminum and can
cause electrical shorts. The proper wiring and receptacle
is a copper wired power cord with a copper wired recep-
tacle.
Dryers operating on 208 volt power supply will have
longer drying times than dryers operating on 240 volt power
supply.