Download Print this page
GE WE25X10018 Installation Instructions
GE WE25X10018 Installation Instructions

GE WE25X10018 Installation Instructions

Stack bracket kit

Advertisement

Quick Links

!Insta"ation
IStac"
Brac"e
K't I
nstru ctl
O
ns
w ,x10018
BEFORE YOU BEGIN
Read these instructions
completely
and
carefully.
• IMPORTANT-
Save t hese
instructions
for local
electrical
inspector's
use.
• IMPORTANT-
Observe all
governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with
the Consumer.
• Note to Consumer
- Keep these
instructions
for future
reference.
• Installation
must
be performed
by a
qualified
installer.
• Proper
installation
is the responsibility
of
the installer.
FOR YOUR SAFETY:
-&WARNING
• Electric
Shock
Hazard.
Disconnect
power
before
installing.
Failure
to do so could
result
in serious
injury
or death.
• Potential
Personal
Injury.
More than
two
people
are recommended
to lift the dryer
into position
because
of its weight
and
size. Failure to do so could result in
personal
injury or death.
• Avoid
Tipping
and Rupture
of Utility
Services.
Dryer
must
be securely
attached
to the washer.
DO NOT place the washer
on
top of the dryer.
Failure
to do so could
result
in personal
injury/death
or property
damage.
• Mobile
Home
or Manufactured
Home
Installation
- Stacking
of a gas dryer
is not
permitted
in a mobile
home
or
manufactured
home.
MINIMUM
CLEARANCE
OTHER
THAN ALCOVE OR CLOSET
INSTALLATION
Minimum
clearance
to combustible
surfaces
and for air opening
are: 0" both
sides and 1"
rear. Consideration
must
be given
to provide
adequate
clearance
for installation
and
service.
ALCOVE OR CLOSET INSTALLATION
• If your
dryer
is approved
for installation
in
an alcove
or closet,
it will
be stated
on a
label
on the dryer
back.
• The dryer
MUST
be vented
to the outdoors.
Refer to dryer
Installation
Instructions
for
details.
Minimum
clearance
between
dryer
cabinet
and adjacent
walls
or other
surfaces
is:
0" either
side
3" front
and rear
Minimum
vertical
space from
floor
to
overhead
cabinets,
ceiling,
etc. is 43"
without
pedestal,
55" with
pedestal
and
84" stacked.
Closet
doors
must
be Iouvered
or otherwise
ventilated
and must
contain
a minimum
of
60 square
inches
of open
area equally
distributed.
If the closet
contains
both
a
washer
and a dryer,
doors
must
contain
a
minimum
of 120 square
inches
of open
area equally
distributed.
175D1807P508
49-90240
05-05 JR

Advertisement

loading

Summary of Contents for GE WE25X10018

  • Page 1 !Insta"ation IStac" Brac"e K't I nstru ctl w ,x10018 MINIMUM CLEARANCE OTHER BEFORE YOU BEGIN THAN ALCOVE OR CLOSET Read these instructions completely INSTALLATION carefully. Minimum clearance to combustible surfaces • IMPORTANT- Save t hese and for air opening are: 0" both sides and 1"...
  • Page 2 mnstaliation mnstructions KIT CONTENTS [TI REMOVE THE DRYER LEVEUNG LEGS Right Hand Bracket Carefully tay the dryer on its side. Use the packing material so you don't scratch the finish on the dryer. Left Hand Bracket 4 Rubber Pads 4#12 x 1" Screws Use an open=end wrench or piiers...
  • Page 3 Installation Instructions INSTALL BRACKET TO DRYER iNSTALL DRYER AND BRACKET ON WASHER Align the holes in the left bracket with the holes in the bottom left corner of the Lift the dryer on top of the washer. dryer. Use a Phillips screwdriver to install Be careful...
  • Page 4 installation instructions FiNALiZE THE iNSTALLATiON Refer to the washer installation instructions to complete the washer installation. Refer to the dryer Instathfion Instructions to complete the dryer installation. Carefully slide or walk the stacked washer and dryer into ptace. Use fett pads or other sliding...