GE Advantium PSB2200 Installation Instructions Manual page 8

Installation Preparation
Preparation WITHan AccessoryStorage Drawer
NOTE:MODELZSC2202CANNOTBE INSTALLED WITH AN ACCESSORY S TORAGE DRAWER. S EEINSTALLATION PREPARATION
WITHOUTAN ACCESSORY S TORAGE DRAWERFORTHISHODEL.
PREPARE THE OPENING (CONT.)
Installation over a GE/Nonogram Oven:
30" 23-1/2"
45-1/4"
Min.
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2x4 or 2x2
Runners all
/ Four Sides
2" Min.
(3" recommended)
Per Oven
Requirement
/
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
° If you are replacing a GE/lonogram electric
double oven with the combined installation of
an Advantium 240V and a single oven, use the
dimensions shown. The middle rail separating
the two openings mau need to be larger than
the 2" minimum shown.
PREPARE THE OPENING (CONT.)
Installation over a GE/Monogram Oven and
Warming Drawer:
ConstructSolid
30" 23-I/2" Bottom Min.
3/8" Plywood
Supportedby
2x4 or 2x2
Runnersall
/ FourSides
2" Min.
(3" recommended)
Per Oven
Requirement
2" Min.
45-1/4"
Min. ,Perwarmingdrawerrequirement
/
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
NOTE: Additional clearances between the cutouts
mau be required. Check to be sure the oven
supports above the Warming Drawer location do
not obstruct the required interior depth and height.
See Warming Drawer installation instructions for
details.
CAUTION: For personal safetu, the mounting
surface must be capable of supporting the cabinet
load, in addition to the added weight of this
approximate 80-pound oven and 50-pound
drawer, plus additional oven loads of up to 50
pounds or a total weight of 160 pounds.
8