Mountthe Microwave Oven - GE JVM1540MP2SA Installation Instructions Manual

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
[_ Place tile blower unit back into tile opening.
at
CAUTION: Do
not pull or
stretch
the blower unit wiring. Make sure the wires are
not pinched.
[]Close tile blower (loot. Secure tile blower
and blower (loot to tile microwave oven using
tile retaining screws fiom Steps 1 and 2.
Blower --------_$'
Retaining _ Blower
Screw_
%
___,<}7_ __'_*----Blower Motor Door
.... _ _b_--_y 'i_<%r-._ RetainingScrew
_<__ _, -- Blower
Backof RetainingScrew
Microwave
Oven
MOUNTTHE MICROWAVE
OVEN
CAUTION: for EASIER
INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL
THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use tile nylon
grommet around tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using fillet blocks if the
cabinet fiont hangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE: When mounting
tile microwave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling cord.
_Lifl microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
)late.
/
_ Rotate flont of oven
up against cabinet
bottom.
21