Page 4
Clarus-series drivers, allowing for upgrade potential with the pressed paper cone diaphragm to ensure from these product lines to the Clarus series. 1” (25mm) (C5) and 1.4” (35mm) (C6): complimentary effort in research and that the speaker’s response remained linear into the design.
Page 5
(C5 or C6) and high pass (C1). The C51-2 response over the extent of its range. At Hybrid dedicated non-inductive resistors; tweeter...
Page 10
Clarus speakers installed by and avoid pressing your thumb or fingers against an authorized Hybrid Audio Technologies dealer. The Clarus speakers are an incredible the cone of the midbass – never test the speaker’s As mentioned in the Welcome and high-end speaker system, but will only be as good as the installation;...
Page 11
In a basic system, the Clarus midbass speakers were designed to be installed in the original Hybrid Audio Technologies designed the Clarus-series to be configured with the tweeter factory speaker locations, most often in the vehicle’s doors (more advanced locations that...
Page 13
The previous section detailed a typical, basic installation of the Clarus product. In this section, right-hand drive vehicle---PLD’s are always a positive number): Hybrid Audio Technologies has prepared a more advanced topical discussion of Clarus installation X – Y = Z...
Page 15
We want nothing more than to know there are great sounding fiberglass (or wood treated with fiberglass resin). Hybrid Audio Technologies recommends the audio systems around the world using our products, and you’d make us all very proud if you use of a solid hardwood, such as birch or oak, namely because these woods are stiff and help to became a student of music and learned its beauty and passion.
Need help?
Do you have a question about the Clarus C5 and is the answer not in the manual?
Questions and answers