Hubbell Anderson PW115V-HD Service And Operation Manual

Material Safety Data Sheet
Material Safety Data Sheet
AW Hydraulic Oil ISO 46
HMIS (US): Health Hazard
Fire Hazard
Reactivity
Personal Protection
NFPA (USA): Health Hazard
Fire Hazard
Reactivity
Specific Hazard
Rating 0 Insignificant
1 Slight
2 Moderate
3 High
4 Extreme
Section 16. Other Informations
Prepared by: SPX Fluid Power
5885 11th Street
Rockford, IL 61109, USA
Phone: 815-874-5556
Fax: 815-874-7886
Date of preparation: November, 2007
The information presented herein has been
compiled from source considered to be depend-
able and accurate to the best of SPX Fluid Power
knowledge; however, SPX Fluid Power makes
no warranty whatsoever, expressed or implied,
of Merchantability or Fitness for the Particular
Purpose, regarding the accuracy of such data or
the results to be obtained from the user thereof.
SPX Fluid Power assumes no responsibility for the
injury to recipient or to the third persons or for any
damage to any property and recipient assumes all
such risks.
Rev. 2
Page 16 of 16
1
1
0
8
1
1
0
none
Manual M-800 Rev. 6/09
Page 3
SERVICE AND OPERATION MANUAL
PW115/230V-HD HYDRAULIC POWER PUMP
NOTE: Read and carefully follow these instructions. Most problems with
new equipment are caused by improper operation or installation.
To help avoid personal injury:
Hydraulic Hose
• Before operating the pump, all hose connections must be tightened
with the proper tools. Do not overtighten. Connections should only be
tightened securely and leak-free. Overtightening can cause premature
thread failure or high pressure fittings to split at pressures lower than
their rated capacities.
• Should a hydraulic hose ever rupture, burst, or need to be disconnected,
immediately shut off the pump and shift the control valve twice to release
all pressure. Never attempt to grasp a leaking hose under pressure with
your hands. The force of escaping hydraulic fluid could cause serious
injury.
• Do not subject the hose to potential hazard such as fire, sharp surfaces,
extreme heat or cold, or heavy impact. Do not allow the hose to kink,
twist, curl, or bend so tightly that the oil flow within the hose is blocked
or reduced. Periodically inspect the hose for wear, because any of these
conditions can damage the hose and result in personal injury.
• Do not use the hose to move attached equipment. Stress can damage
the hose and cause personal injury.
• Hose material and coupler seals must be compatible with the hydraulic
fluid used. Hoses also must not come in contact with corrosive materials
such as creosote-impregnated objects and some paints. Consult the
manufacturer before painting a hose. Never paint the couplers. Hose
deterioration due to corrosive materials can result in personal injury.
H U BB ELL
Power Systems
Manual M-800 Rev. 6/09
ELECTRIC
TWO-STAGE HYDRAULIC PUMP

SAFETY PRECAUTIONS

!
WARNING
®
Page 1 of 16