Assembly Instructions - Health O Meter 1101KL Operation Manual

ASSEMBLY INSTRUCTIONS

Parts List:
(1) Platform Assembly
(1) Handrail Assembly
(4) Rubber Feet
(1) AC Adapter Holder
This 1101KL scale has been calibrated at the factory. Remove each assembly from its carton
and unwrap packing material carefully to prevent scratching the unit's parts.
1. Place the platform assembly upside down on a level floor.
2. Screw the four feet onto the platform assembly.
3. Prepare the platform assembly for installing to the handrail assembly as follows (use
7/16" or 11mm wrench):
- Unscrew 2 screws from the both sides of the platform assembly.
- Unscrew 4 nuts from the both sides and from the back of the platform assembly.
- Keep these screws and nuts for reinstalling in the same locations.
4. Hold the handrail assembly perpendicular to the platform assembly, as shown in
Figure 1.
5. Attach the handrail assembly to the platform assembly, install 2 screws at both sides of
the platform and then 4 nuts at both sides and at the back of the platform.
6. Plug the handrail cable connector into the platform assembly.
7. Install the AC adapter holder on the interior right side of the handrail using two screws
attached to the holder assembly.
8. Adjust the rubber feet for equal stabilization of the scale.
The scale may be operated by an AC power source adapter or by 6-C cell batteries.
The scale will automatically switch to battery operation when an AC power source is absent.
Figure 1. Assembly After Shipment
3