What To Do If; Environment Concerns - Chef EHC657U User Manual

2. Clean the appliance with a moist cloth
and some detergent.

What to do if...

Problem
You cannot activate the appli-
ance or operate it.
The appliance deactivates.
The residual heat indicator
does not come on.
The sensor fields become hot.
comes on
comes on
and number comes on.
comes on
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.

Environment concerns

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
3. At the end rub the appliance dry
Possible cause and remedy
• Activate the appliance again and set the heat setting in 10 sec-
onds.
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the con-
trol panel.
You put something on the
sor field.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.
The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
• No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the
cooking zone. Move cookware to a smaller cooking zone.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the service cen-
tre.
There is an error in the appliance, because a cookware boils dry.
The protection against become too hot for the cooking zone op-
erates. The Automatic Switch Off operates.
Deactivate the appliance. Remove the hot cookware. After, ap-
proximately 30 seconds activate the cooking zone again.
should go out of the display, residual heat indicator can stay. Let
the cookware become sufficiently cool and check it with the sec-
tion Cookware for the induction cooking zone.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
with a clean cloth.
. Remove the object from the sen-
9