Page 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,...
Page 2
Important Notes to the Installer Stepping, leaning or sitting on the doors Read all instructions contained in these installation or drawers of this range can result in serious injuries and instructions before installing range. can also cause damage to the range. Remove all packing material from the oven compartments •...
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
Page 4
Level and Position Range- Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to checkyour adjustments.
Page 5
5. Read electrical connection details below Manual Flare Flexible Flare Union Pressure and connect electricity to range. Shutoff Union Appliance Adaptor Regulator Valve Conduit Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Requirements: A dedicated, properly grounded and polarized branch circuit protected by a 15 amp.
Page 6
Operation of Surface Burners 7. Electric Ignition Surface Burners Operation of electric igniters should be checked after range Installation of Surface Burner Caps and supply line connectors have been carefully checked for Your range is equipped with any combination of the sealed leaks and range has been connected to electric power.
Page 7
seconds after the thermostat is turned ON before the flame 8. Adjust the "LOW" Setting of Surface Burner appears at the oven burner. When the oven reaches the dial Valve (Linear Flow Valves Only): setting, the glowing igniter will go off. The burner flame will go "out"...
If theflameis yellowin color,increase air shutter opening Care, Cleaning and Maintenance size.(See "2" in illustration below.) If the flame is a distinct Refer to the Use & Care Guide for cleaning instructions. blue, reduce the air shutter opening size. To adjust loosen lock screw (see "3" illustration below), If removing range...
This manual is also suitable for:
790788194047907881440479078824404790788294047907881240479078814402...
Show all