Adjusting Volume And Reverb; Layering Two Sounds (Dual) - Kawai Anytime Owner's Manual

4. ADJUSTING VOLUME AND REVERB

5. LAYERING TWO SOUNDS (DUAL)

Plug headphones into the HEADPHONE JACKS on the front panel of the Control
Box. Find the volume knob on the front panel of the Control Box and adjust the
volume appropriately.
Then adjust the reverb setting to suit your taste. Reverb adds a rich ambient effect to
the digital sound. There are five reverb settings available:
ROOM 1 & 2: Offers a soft reverberation, simulating the sound of a small room
STAGE : Simulates the sound of playing on stage
HALL 1 & 2: Simulates the deep reverberation of a large concert hall
Hold down the REVERB button for more than one second to select the reverb. To
select the reverb type, while holding down the REVERB button press "VALUE +" or
"VALUE - " button to select. After you have selected the reverb type, let go of the
REVERB button and it goes back to sound selection screen.
You can switch the Reverb on/off each time you press the REVERB button. When the
reverb is on, the LED will be lit.
You can also select the reverb by using pedal and keyboard in "Setting Mode" (see Page
22).
To access the button on the Control Panel with the grand piano, there is a place where
you can place your hand on the cheekblock to lift it up.
You can combine the piano sound with a tone selected from the Assignable sounds and
layer them across the keyboard. This function is called "DUAL".
To try DUAL, select a sound that you wish to use with the PIANO button and OTHERS
button and the sound you have selected first will be displayed in the top line of the
screen.
To select Jazz Organ, Drawbar Organ; while holding down the PIANO button, press
OTHERS button once again.
You can adjust the volume balance between the two sounds in VIRTUAL
TECHNICIAN MODE (see Page 14). To leave the DUAL function, simply press
either the PIANO button or the OTHERS button.
- 9 -