Table of Contents
Advertisement
Video output
Connector(s) from source to Swivel
from source
VGA
VGA to Cinemin™ Swap* to 3.5 mm-3.5 mm cable to Swivel
DVI, Mini-DVI, or
DVI, Mini-DVI
Micro-DVI
or Micro-DVi
connector
DVI to VGA, S-Video or Composite connector to Swap* to Swivel
Mini DisplayPort
Mini
DisplayPort
connector**
Other sources
Device's
of video output
proprietary
devices
connector**
*Sold separately.
**Sold separately by third parties.
VGA, S-Video,
or Composite
connector**
VGA, S-Video,
or Composite
connector**
Swivel
compatible
connector**
Using Swivel with your device
To start using your Swivel:
1.
Install the battery, connector
end first (A) and label side
up (B), as illustrated.
2.
Remove the protective film
as indicated on Swivel.
3.
Connect your media
source to the Swivel
(refer to Connecting to a
video source).
4.
Slide the power switch to ON
The LED indicator will light up and Swivel will briefly project a Cinemin logo.
Swivel will detect the connected device.
5.
Play the media on your media source device. Swivel will project the media
where it is pointed at a fixed 480 x 320 pixel resolution.
6.
When powered by battery, Swivel will automatically go into standby mode after
15 seconds if there is no input video signal.
For optimal performance, keep your Swivel powered via USB while in use by connecting it
to a USB power source or by using the AC adapter.
NOTE: Swivel's audio levels reset to default levels after you turn it off.
B
A
A
or to REVERSE
.
3
Hide quick links:
Advertisement
Table of Contents
