Behringer ULTRABASS BX4500H Quick Start Manual page 7

12
ULTRABASS BX4500H
ULTRABASS BX4500H Controls
(1) (3) (5) (7)
(2) (4) (6) (8)
BX4500H Front Panel
(21)
(22) (23) (24)
BX4500H Rear Panel
(9) (10) (11) (12) (14) (16)
(13) (15) (17) (18)
(25)
13
Quick Start Guide
Controls
(EN)
(19)
(20)
(1) The LEVEL VU meter reads the level that is applied to (18) Connect the RETURN jack to the output of your
the preamp circuitry of the BX4500H. effects device. Since the BX4500H features a serial
effects path, the mix ratio must be set on your
These are the inputs for your electric bass guitar.
(2)
effects device.
The PASSIVE jack is for passive basses, the ACTIVE
jack for active instruments with high output levels. Use the balanced D.I. XLR output to feed the
(19)
audio signal from your ULTRABASS to an external
(3) Use the GAIN control to determine the input gain
mixing console.
on your BX4500H.
(20) Use the LINE OUT jack to connect your BX4500H to
(4) Connect your footswitch to the FOOTSWITCH
a mixing console that has no balanced inputs and/or
jack, so as to control the sub-harmonics processor
to provide a signal that is independent of all settings
and SHAPE filter.
adjusted on the BX4500H.
With the sub-harmonics processor switched on
(5)
Use the POWER switch to switch the BX4500H
(21)
(see ) you can add ultra-low bass frequencies
(6)
on or off.
to your sound by turning the ULTRABASS control
MAINS CONNECTION.
(22)
(6) Press the ULTRABASS switch to enable the
sub-harmonics processor. (23) FUSE HOLDER/VOLTAGE SELECTOR.
The BASS control in the EQ section allows you to SERIAL NUMBER.
(7) (24)
boost or cut the bass frequencies at approx. 50 Hz.
Use the SPEAKER outputs to connect your
(25)
Press the DEEP switch to add low frequencies
(8) loudspeakers. The outputs are wired in
(ranging from 30 - 200 Hz) to your bass sound. parallel on two ¼" jacks and a professional
loudspeaker connector.
(9) This control governs the upper bass-frequency range
at approx. 140 Hz.
The MIDDLE control allows you to boost/cut the low
(10)
Check Out behringer.com for Full Manual
midrange frequencies at approx. 500 Hz.
(11) This control raises/lowers the high midrange
frequencies at approx. 1.6 kHz.
(12) The TREBLE control governs the high-frequency
range on your BX4500H at approx. 7.5 kHz.
Use this switch to enable/disable the BRIGHT effect,
(13)
which adds some brilliance to the treble frequencies
in the range from 2 - 20 kHz.
(14) When you enable the SHAPE filter with switch (15) ,
you can use the SHAPE control to modify the filter
sound. The filter position is adjustable in the range
from 120 Hz -1.2 kHz.
The SHAPE switch activates the SHAPE filter.
(15)
When the filter is on, the LED above the switch
lights up.
Use the OUTPUT control to determine the overall
(16)
volume of your BX4500H.
(17) Connect the SEND/TUNER output to the
input of your effects device, for example,
our proven multi-effects processor
BEHRINGER VIRTUALIZER PRO DSP2024P.