Installation Manual of Room Air Conditioner Necessary Tools for Installation 1.Driver 2.Hacksaw 3.Hole core drill 4.Spanner(17,19 and 26mm) Accessory parts Number Accessory parts articles Remote controller R-03 dry battery Mounting plate Drain hose 4X50 Steel nail, cement 4X25 Plastic cap...
Page 2
HSU-09LEK13 HSU-09LEK03 HSU-12LEK13 HSU-12LEK03 HSU-07LEK03 HSU-09HEK03 HSU-07HEK03 HSU-12HEK03 To this unit, both liquid and gas pipes shall be insulated as they become Iow temperature in operation. Use optional parts for piping set or pipes covered with equivalent insulation material. Indoor unit 1.Fitting of the Mounting Plate and Positioning of the wall Hole...
Connecting the indoor/outdoor Electric Cable Removing the wiring cover Remove terminal cover at right bottom corner of indoor unit, then take off wiring cover by removing its screws. When connecting the cable after installing the indoor unit 1. Insert from outside the room cable into left side of the wall hole, in which the pipe has already existed.
Outdoor unit 1.Connection of pipes To bend a pipe, give the roundness as large as possible not to crush the pipe Connecting the pipe of gas side first makes working easier. The max vertical distance between the indoor unit and the outdoor unit is 5 m. Half union Spanner Be careful that matters, such as wastes of sands, etc.