Advertisement
WARP FILTER
There is a warp filter function which operates at a
very low frequency of around 7Hz. This frequency
was chosen as it is around the common arm/
cartridge resonant frequency and helps to remove
any excessive cone movements in your speakers
due to this as you play a record. It can be disabled
by moving 2 Green jumpers J14 & J15 on diagram
2 to the off positions
WORLDWIDE GUARANTEE
This entitles you to have the unit repaired free of
charge, during the first ten years after purchase,
provided that it was originally purchased from
an authorised Talk/Edwards Audio dealer or
distributor. The manufacturer can take no
responsibility for defects arising from accident,
misuse, abuse, wear and tear, neglect or through
unauthorised adjustment and/or repair, neither
can they accept responsibility for damage or loss
occurring during transit to or from the person
claiming under the guarantee. THE WARRANTY
COVERS Parts and labour costs for ten years from
the purchase date. After ten years you must pay for
both parts and labour costs. The warranty does not
cover transportation costs at anytime.
Telephone: 08456 123388 or 07736 421928 Fax: 01276 613250
email:
Edwards Audio
Edwards Audio
is part of
3 Eliot Close, Camberley, Surrey GU15 1LW UK
info@talkelectronics.com
CLAIMS UNDER GUARANTEE
This equipment should be packed in the original
packing and returned to the dealer from whom
it was purchased, or failing this, directly to the
Talk/Edwards Audio distributor in the country of
residence. It should be sent carriage prepaid by a
reputable carrier – NOT by post. No responsibility
can be accepted for the unit whilst in transit to the
dealer or distributor and customers are therefore
advised to insure the unit against loss or damage
whilst in transit.
The Edwards Audio MM1 has been manufactured
to conform with the protection requirements of
the EC Council directive 89/336/EEC relating to
EMC by application of the following standards:
EN500811 1997 Emissions Standard
EN500821 1997 Immunity Standard
and also the requirements of the EC low voltage
directive relating to electrical safety by application
of the following standard:
BSEN/IEC60065: 2002 International Safety
Standard. For the purposes of testing the MC2 was
used with the high quality interconnects supplied
by Merlin Cables. Compliance with the above
standards may only be made if the unit is installed
as per this manual and using the correct cables.
SPECIFICATIONS
Max Input MC .......................................................... 10mV
Nominal Input ...................................................... 0.11mV
Max Gain MC input (MM) ...............................63dB(40dB)
THD Distortion .................<0.006% 1kHz <0.02% 20kHz
Signal to noise ......................................72dB AWeighted
RIAA ............................................................ within 0.25dB
Frequency response....................20100kHz within 0.3dB
Stereo separation better than .................55dB 2020kHz
Input Loading MC/MM ......100R with 2n2/47K with 120pF
Output impedance ............................................ <10 Ohms
Nominal output ...............................................100mV 1V
Max output level ..................... 9.8v depending upon input
Dimensions WxHxL ........... 114.5mm x 47.5mm x 160mm
Weight ...................................................................... 0.5kg
TALK Electronics
website:
www.talkelectronics.com
Advertisement
