NETGEAR GS700TP Software Administration Manual page 117

GS700TP Smart Switch Software Administration Manual
• "Advanced"
Basic
The STP Basic menu contains the following options:
• "STP Configuration"
STP Configuration
The Basic STP Configuration screen contains parameters for configuring STP on the device.
To configure STP on the device:
1. Click Switching > STP > Basic > STP Configuration. The Basic STP Configuration screen
displays:
Figure 4-20
The Basic STP Configuration screen contains the following fields:
Global Settings
• Spanning Tree State – Select the STP state on the device. The possible field values are:
– Enable – Enable STP on the device.
– Disable – Disable STP on the device.
• STP Operation Mode – Select the STP mode on the device. The possible field values are:
– STP – Enable classic STP on the device.
– RSTP – Enable Rapid Spanning Tree Protocol (RSTP) on the device.
4-30
v1.0, April 2008
Configuring Switching Settings