Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for H2O Audio iDV1-75
Summary of Contents for H2O Audio iDV1-75
- Page 2 D e e p D i v e W a t e r p r o o f C a s e & S p e a k e r s D e p t h R a t i n g 3 0 0 f t / 9 0 m For updated manuals please visit our web site www.h2oaudio.com iDV1-75 20080819...
- Page 3 Mask Clip Speaker Depth Rating 300ft / 90m Cam Knob Lock iPod ® Control Buttons Cam Knob O-ring Lanyard Hole Insert Holes & Height Adjuster Holes LED lights Battery Cover Connector Cable...
- Page 4 Quickstart: I. Read “Getting Familiar with the iDive 300” II. Unlock and open case III. Install batteries (3 AA) IV. Install iPod specifi c inserts and height adjusters (see page 10 for fi t chart) V. Install iPod VI. Turn on iPod VII.
- Page 5 3. The O-ring and contact surface have scratches and other imperfections. Replacement H2O Audio has provided an extra O-ring. The O-ring should be replaced annually or in the event of damage, loss, overexposure to direct sunlight, or become misshaped through misuse. To replace the O-ring: 1.
-
Page 6: Install Batteries
To Close Case 1. Close lid 2. Rotate the cam knob clockwise 180° 3. Close the cam knob lock IV. Install batteries 1. Open case. 2. Disconnect and remove iPod from case if installed. 3. Turn the battery cover screw counter-clockwise until the screw loses contact with the insert plate. 4. - Page 7 Included insert and height adjusters Inserts and height adjusters are labeled to aid identifi cation. Insert A Insert B Insert C Insert D As new iPods become available please check our web site for updates on Inserts and height adjusters. iPod touch Height Adjuster 1 Height Adjuster 2...
-
Page 8: Power On/Off
2. Place iPod in the inserts with the iPod dock connector facing toward the cam knob. 3. Insert the connector cable into the dock connector of the iPod with the H2O Audio logo facing up. 4. Depending on your iPod model, press and hold the “Play / Pause” button or press the Power button to turn the iPod on. -
Page 9: Mode Button
For long-term storage, store in a cool dry place out of direct sunlight. CAUTION: The life of a O-ring is typically one (1) year. Contact H2O Audio for spare O-rings and silicone grease. Always remember to reinstall the O-ring before next use. Do not expose the case to extreme heat, such as the inside of a hot car, or in direct sunlight, such as on a beach, or boat deck. - Page 10 Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifi cations to this equipment. Such modifi cations could void the user’s authority to operate the equipment. XII. General Use Notice Read this manual carefully. If you have any questions please contact H2O Audio customer support prior to use.
-
Page 11: Warranty Coverage
Warranty claims involving personal property damage will be put through a series of tests to determine if the product has been misused or improperly cared for. Should a product be determined by H2O Audio to have manufacturing or material defects which resulted in damage to personal property, H2O Audio, at its’... - Page 12 At full depth, the force of the sound waves is mitigated by the water pressure. At lesser depths or on the surface, this loud volume can damage your hearing. As a safety precaution, the iPod volume is set to ¼...
- Page 13 Q: Why is the Red LED fl ashing? A: The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power the “Made for iPod” connection electronics and the power amplifi er. The Red LED will start to fl ash when the batteries have approximately 25% charge remaining.
- Page 14 Copyright Notice: This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered trademarks of Apple Inc.