Advantech L-Band Satellite Modulator Installation And Operation Manual page 5

Safety Notices
Radio Frequency (RF) Interference
This equipment generates, uses and can radiate radio frequency energy, and, if not installed in
accordance with the instructions contained herein, may cause interference to radio communications.
It has been tested and found to comply with the limits for a Class A computing device pursuant to
Subpart J of Part 15 of the Federal Communications Commission rules, which are designed to provide
reasonable protection against such interference, when operating in a commercial environment.
Operation of this equipment in a residential area is likely to cause interference. In this case, the user is
required to take whatever measures are necessary to correct the interference at the user's expense.
If radio frequency interference is encountered after the installation of this equipment, corrective
measures are required to reduce the interference. Information on recommended measures can be
obtained from the manufacturer.
United Kingdom
1. TO ENSURE ADEQUATE COOLING OF THE EQUIPMENT, A 2.0-INCH UNOBSTRUCTED SPACE MUST
BE PROVIDED AROUND ALL SIDES OF THE UNIT.
2. THE AC POWER SOCKET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY
ACCESSIBLE.
3. REMOVE POWER PLUG FROM THE POWER SOCKET BEFORE PERFORMING ANY SERVICE WORK
ON THE UNIT.
4. ONLY FACTORY AUTHORIZED SERVICE PERSONNEL SHOULD PERFORM SERVICE ON THIS UNIT.
FAILURE TO OBSERVE THIS WARNING CAN RESULT IN MALFUNCTION TO THE UNIT AS WELL AS
ELECTROCUTION TO PERSONNEL.
France
1. AFIN DE NE PAS NUIRE AU PROCESSUS DE REFROIDISSEMENT, IL EST NÉCESSAIRE DE LAISSER
UN ESPACE D'ENVIRON 5 CM DE CHAQUE CÔTÉ DE L'APPAREIL.
2. PLACEZ L'APPAREIL PRÈS D'UNE PRISE DE COURANT FACILEMENT ACCESSIBLE.
3. DÉBRANCHEZ L'APPAREIL AVANT DE L'OUVRIR.
4. CET APPAREIL NE PEUT ÊTRE EXAMINÉ OU RÉPARÉ QUE PAR UN EMPLOYÉ AUTORISÉ DU
FABRICANT. SI CETTE CONSIGNE N'EST PAS RESPECTÉE, IL Y A RISQUE DE PANNE ET/OU
D'ÉLECTROCUTION.
Germany
1. UM DIE KÜHLUNG DES GERÄTES NICHT ZU BEEINTRÄCHTIGEN, IST ES NOTWENDIG, AN ALLEN
SEITEN DES GERÄTES CA. 5 CM RAUM ZU LASSEN.
2. STELLEN SIE DAS GERÄT IN DER NÄHE EINES GEERDETEN SCHUTZKONTAKTSTECKERS SO AUF,
DASS DER STECKER LEICHT ERREICHBAR UND ZUGÄNGLICH IST.
3. VORM ÖFFNEN DES GERÄTES MUSS DER NETZSTECKER VOM STROMNETZ GETRENNT WERDEN.
4. DIESES GERÄT DARF NUR DURCH DAS BEVOLLMÄCHTIGTE KUNDENDIENSTPERSONAL DER
FABRIK INSTANDGEHALTEN WERDEN. DIE NICHTBEACHTUNG DIESER VORSCHRIFT KANN ZU
FEHLFUNKTIONEN DES GERÄTES FÜHREN UND DAS PERSONAL DURCH STROMSCHLÄGE
GEFÄHRDEN.
SBM75e Series Modulator Installation and Operation Manual
WARNING
AVERTISSEMENT
VORSICH
Preliminary Pages
v