Emcore EOS-6000 Series User Manual

Optical a/b switch

Advertisement

Quick Links

EOS-6000 Series
Optical A/B Switch
User Manual – DC Version
For more information on this and other products:
Contact Sales at EMCORE 626-293-3400, or visit www.emcore.com.

Advertisement

Table of Contents
loading

Summary of Contents for Emcore EOS-6000 Series

  • Page 1 EOS-6000 Series Optical A/B Switch User Manual – DC Version For more information on this and other products: Contact Sales at EMCORE 626-293-3400, or visit www.emcore.com.
  • Page 2: Table Of Contents

    Network management ........................11 Output Indication ..........................11 Operation............................12 Manual Switch ..........................12 Normal Operating Condition......................12 Applicable Standards Compliance......................13 EMI/EMC ............................13 Packaging ..............................13 Packaging............................13 2 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 3: Safety Information

    Failure to comply with any of these instructions or with any precaution or warning contained in the user’s manual is in direct violation of the standards of design, manufacture, and intended use of the unit. Emcore assumes no liability for the customer’s failure to comply with any of these safety requirements.
  • Page 4: Getting Started

    Note: Keep the packaging. Immediately inform Emcore and, if necessary, the carrier if the contents of the shipment are incomplete, if the unit or any of its components are damaged or defective, or if the unit does not pass the initial inspection.
  • Page 5 •The unit or any of its components are damaged or defective •The unit does not pass the initial inspection In the event of carrier responsibility, Emcore will allow for the repair or replacement of the unit while a claim against the carrier is being processed.
  • Page 6 DC input of the power supply. The DC power source must be 36 – 60VDC and wires used must handle at least 10VA. 4. Turn the unit power switch to the ON position. 6 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 7: Optical Switch Outline Drawing (Units In Mm)

    EOS 6000 Optical A/B Switch USER MANUAL SEPTEMBER 9, 2008 Optical Switch Outline Drawing (Units in mm) 7 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 8 Some of the optical switch’s capacitors can be charged even when the unit is not connected to the power source. 8 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 9: Operating Environment

    The EOS-6000 is capable of manual switching or can be switched remotely via SNMP adding optical protection to many system applications. 9 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 10: Front Panel View

    Output Com Port Select Switch DC Terminal Block Input Input RS232 Port for management RJ45 Port for management Power Switch 10 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 11: Sample Application

    Sample Application The diagram below shows a typical CATV application that allows fully redundant transmitters and fiber paths, with automatic protection to the network via the EOS-6000 switch. Contact your Emcore sales representative for more information on Emcore’s complementary product lines.
  • Page 12: Operation

    General and Mechanical Specifications PROPERTY REQUIREMENT COMMENTS Switching Threshold 20 dB range – see datasheet Settable within range Switching Mode Auto, Manual, remote 12 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400 Fax: 626-293-3428...
  • Page 13: Applicable Standards Compliance

    The product manual will be installed in an anti-static bag and shipped with the unit MIB’s and manuals will be provided on a CD-ROM supplied with unit 13 of 14 EMCORE Broadband Copyright 2008. EMCORE Corporation 2015 West Chestnut Street Alhambra, California 91803-1542 Tel: 626-293-3400...
  • Page 14: Laser Safety

    Information contained herein is deemed to be reliable and accurate as of issue date. EMCORE reserves the right to change this user manual, the design, or specifications of the product at any time without notice.

Table of Contents