Battery Details - Robosapien 8081 User Manual

Battery Details

BATTERY REQUIREMENTS:
Your robot is powered by 4 x "D" size Alkaline batteries (2 batteries in each foot ).
Your remote controller is powered by 3 x "AAA" batteries.
BATTERY INSTALLATION:
• Be sure the robot power button is in the OFF position (OUT) before installing or changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown.
• Install recommended batteries as shown, making sure battery polarity is correct.
• Replace battery doors and carefully tighten all screws.
IMPORTANT BATTERY INFORMATION
• Do not dispose of batteries in fire. Batteries may explode or leak.
• Do not mix used and new batteries. Replace all batteries at the same
time.
• Do not mix alkaline, standard (Carbon Zinc) or rechargeable (Nickel-
Cadmium) batteries. Only use new batteries of the same type.
• Due to small parts, it is recommended that batteries be installed or
replaced only by adults.
• Batteries must be inserted with the correct polarity or the robot will not
work.
• Dead batteries should be removed so they don't leak and damage the
battery contacts.
• Do not short circuit battery terminals or battery contacts.
• Do not try to recharge non-rechargeable batteries.
• Rechargeable batteries are not recommended for use in this robot.
Low Battery Indicators:
When Robosapien's batteries grow weak, your Robosapien will move and walk very slowly.
- When this occurs, power robot OFF and replace all batteries.
When the remote controller's batteries grow weak, the indicator light will shine very dimly.
- When this occurs, replace all the batteries in the remote controller.
NOTE:
• Robot will just stop when battery power gets VERY low. Power off and replace all batteries.
• Some lighting or sunlight can interfere with Infra-Red signals Move the robot into shadow.
P.3
Robosapien
1.5V
1.5V
"D"
"D"
LR20
LR20
UM1
UM1
1.5V
1.5V
"D"
"D"
LR20
LR20
UM1
UM1
Base of Feet
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
Remote
Control
Bottom View