Suspended Installation; Rotatable Horn - Yamaha IF2115/AS(W) Owner's Manual

Bi-Amp/Passive switch
Select the Bi-Amp mode (bi-amp drive) or
the Passive mode (full-range drive).
CAUTION
Do not change the Bi-amp/Passive setting
while the speaker is in use.
Neutrik Speakon NL4 plug wiring
Connect the plugs as shown below.
CAUTION
Be sure to use proper speaker cable – not
shielded instrument or line cable – for all
speaker connections.
NEUTRIK plug Bi-Amp
1+
1–
2+
2–
NOTE The Speakon jack and barrier strip terminals are
connected in parallel.

Suspended Installation

CAUTION
• The strength of the suspension points on the speaker is
per point (maximum).
• Before doing any installation or construction work, consult with an
installation expert.
• When choosing the installation location, suspension wire and
mounting hardware, make sure all are strong enough to support
the weight of the speaker.
• Some fittings may deteriorate over extended periods of time due
to wear and or corrosion. For optimum safety, the installation
should be checked thoroughly at regular intervals.
Yamaha cannot be held responsible for damage or injury
caused by insufficient strength of the support structure
or improper installation.
■ Using eye bolts for suspension
For opt imum safety, make sure to carefully follow the
ions below.
precaut
CAUTION
• Use only the supplied eye bolts.
• Use three or more eye bolts for suspended installations.
• Use the optional array frame if you intend to suspend a speaker
from another suspended speaker.
• Install the eye bolts to multiple surfaces of the speaker, not just
one surface.
1-
2+
Passive
LF+ +
LF– –
HF+
HF–
60 kg
■ Eye bolt strength
Keep in mind that the strength of the eye bolt differs
depending on the suspension angle of the speaker. Make
sure that the load for each eye bolt is less than 740 kg when
suspending at an angle of 0 degrees, and less than 185 kg
at an angle of 45 degrees.
CAUTION
When using the eye bolts,
make sure that the suspension
angle is within the range of 0
to 45 degrees, as shown
below.
CAUTION
1+
Do not suspend the eye bolts as shown
in the diagram below.
2-

Rotatable horn

NOTE The horn directivity of the speaker is set at the factory so
that the upward spread is narrow and the downward
spread is wide.
1.
Remove all fixing screws on the grille, and remove the
grille from the speaker.
2.
Remove all screws installed on the horn, pull out the horn
from the speaker, rotate the horn 90 degrees, and
re-install the horn to the speaker.
CAUTION
Be careful when rotating the horn so that you do not accidentally cut
the connection wires connected to the horn driver.
Narrow
Wide
Vertikal
NOTE If you use the speaker as a floor monitor, change the horn
dispersion so that the upward spread is wide and the
downward spread is narrow, as shown in the diagram.
Wide
Narrow
0º (740kg)
45º (185kg)
90º (148kg)
Rotate 90 degrees
Narrow
Wide
Horizontal
Horizontal
IF2115/2112AS Owner's Manual
3