SAFETY NOTES ENVIRONMENTAL The following warnings and precautions are for your Do not spray aerosol cleaners directly on to its safety and the prevention of injury. Read them carefully surfaces when cleaning. and observe at all times when installing or operating Do not spill water onto the control unit.
Page 5
Hotline; this will help us to respond promptly to your EEC Directive 93/97/EEC Satellite earth station request. equipment. Telephone: (01245) 355398 EEC Directive 73/23/EEC Low voltage directive International: +44 1245 355398 e2v technologies’ quality management system is certificated to the requirements of ISO 9001. HBN6081-1 page 3...
1 Thank You For 2 Care of the Buying Stellar Control Unit Thank you for buying this Stellar product. This e2v 2.1 Storage technologies control unit allows the remote control of Store the control unit in its normal horizontal one Stellar amplifier.
As there are many installation variations, the cabling between the amplifier and control unit is not provided The N6081 will now search through the 64 available as standard. Contact e2v technologies for details of addresses at a Baud rate of 9600 until communication interface cable accessories.
The display will then show the following: 4.6 Off Press the "OFF" key and the Amplifier will return to the off mode. The display will then show the following: 4.3 Warm-up Press the STBY or XMIT key whilst in the "OFF" state to begin the TWT cathode warm-up process (180 The Amplifier cooling fans will continue to rotate at full seconds).
5 Measurement and 6 Gain Setting Monitor Functions (Only available on the N6081D) 5.1 Power (watts) The Amplifier must be fitted with a digital attenua- tor (DEVA) for this facility. Once the N6081 has found an amplifier, its display will show the amplifier’s forward power in watts.
7 Amplifier Interface 7.3 Interconnections for -01 variant (see also 7.1 Introduction Appendix B) Connection to the Stellar Amplifier is made via a 15- way D-type socket for the N6081X series or a 26-way 41-way amplifier 26-way high density D-type plug for the N6081X-01 series. connector D-type socket The control unit obtains its power supply (15 V,...
. . 150 mm (6 inches) Weight (nominal) ..0.5 kg (1.1 pounds) 9.3 Environmental For operation outside these parameters, refer to e2v technologies for guidance. Operating temperature ..0 to +50 8C Storage temperature .
Page 14
Appendix B TO N631X 41-WAY CONTROL CONNECTOR 26-WAY HIGH DENSITY D PLUG (PL1) OFF S/O OFF S/O WARM UP S/O WARM UP LED STANDBY S/O STDBY LED TRANSMIT S/O XMIT LED SUM. FAULT S/O FAULT S/O 0 V (B) OFF C/I OFF SWITCH STANDBY C/I STDBY SWITCH...
Page 15
DR No: Comments And Observations: Please complete this form prior to using the E2V Technologies ‘STELLAR HOTLINE’; it will help us respond promptly to your request. Be aware that telephone conversations may be recorded. The completed form may also be faxed or mailed to the address above and should be sent with any unit returned to E2V Technologies for repair.