Page 1
Jabra HANDSET™ 450 for Cisco USER MANUAL...
Page 2
Contents jabra HanDset 450 For CisCo overview......2 ConneCting ..................3 How to use tHe jabra HanDset 450 For CisCo ...4 teCHniCal speCiFiCations............6 Jabra HaNDSET 450 for CiSCo...
Handset 450 for Cisco, press and hold (5 secs) the mute microphone button. press the mute microphone button again, to turn back on. the jabra Handset 450 for Cisco cannot be turned off if the cradle is plugged into a pC that is turned on.
1. Connect the usb cable to the handset cradle, and then plug the usb cable into any available usb port on your pC. 2. Dock the jabra Handset 450 for Cisco in the handset cradle. the handset and the cradle are already paired. to pair a new handset with the cradle, simply dock the new handset in the cradle.
HoW to use tHe Jabra Handset 450 for CisCo speaker down indicator Mute microphone speaker up usb port answer call pick up the handset end call Dock the handset in the cradle tap the Volume up or adjust speaker Volume down button...
Page 6
Handset 450 for Cisco is in pairing mode incoming call active call voicemail* the handset is out of range of the handset cradle Device firmware update mode the jabra Handset 450 for Cisco microphone is muted * vXi only. not for jabber version 9.5 or earlier.
120 hours. if the handset is not docked, it will turn off after 3 minutes. Charging time: less than 3 hours Operating temperature: -10°C to 55°C (14° F to 131° F) Storage temperature: -40° C to 70° (-40° F to 158° F) Jabra HaNDSET 450 for CiSCo...