Connecting To A Television - LG GC990W User Manual

GC990W1_GC480W1_NA2ALL_07V 3/10/04
Connecting to a television
The information given here refers to the two most common forms of connection. Make sure that all the appliances
are unplugged from the mains power, before making any connections to avoid causing damage to your equipment.
Using a AV cable to connect your appliances will give you the best sound and picture quality.
4
Roof aerial
(not supplied)
Video
RF cable
Audio cable
AUDIO /
VIDEO OUT
Video cable
Note : GC480W/GC260W have no
AUDIO OUT (R) sockets.
Aerial in
RF out
1:56 PM Page 4
Connection guide
Television (not supplied)
Roof aerial
Your outside aerial should be
connected to the AERIAL socket
of your Video.
RF cable
If you are using the RF cable a
connection needs to be made from
the RF.OUT socket on your Video to
the aerial socket on your television.
AUDIO/VIDEO IN
AV socket
If you have a AV socket connection
on your television you can connect
the television's AUDIO IN/VIDEO IN
sockets to the AUDIO OUT/VIDEO
OUT sockets on the back of the
Video.
Tune a video channel
If you are using a AV connection then
the video picture will be shown on the
AV channel of your television.
If you are using a RF cable you need
You should use either a RF
to select a Video channel on your
connection or a AV
television and tune it to the Video
connection between your
signal, a test picture.
Video and Television.
Turn on the Video and TV.
Select the vacant position 68 on your
TV.
Press POWER on the Remote
Control to put the Video on standby
then press and hold PROG. 3 or 4
on the front of your Video for more
than 4 seconds. If the test picture
appear clearly on the television
screen, the position 68 is your video
channel.
If the test picture do not appear
clearly, go to next.
Select a vacant position between 28
and 68 on your television.
Press PROG. 3 or 4 on the Video
until the test picture appear clearly on
the television screen.
You can also set the output frequency
to OFF if there is any interference
when your TV is connected to the
Video with a AV cable.
Press POWER on the front of your
video when you have finished.