Table of Contents
Advertisement
Additional Features
The controller also has the capability of operating in metric units and of restoring factory defaults. To access these
features, follow these steps.
Accessing Additional Features
Step 1
A.
Press and hold the P and R buttons at the same time for about 6 seconds. The display should show
only the controller type 18 (model Pro180) or 38 (model ProPlus380) in solid numbers, change to
blinking numbers, and then go back to solid numbers.
B.
Once the numbers are solid again, release the buttons and enter the code P, P, R, P. This code will
enter you into the Unit Selection screen.
Note: Entering any combination other than the above code will put you into Advanced Settings.
Set Units
Step 2
A.
The indicator bar below the digits will blink and the display reads - -, designating the default of
English units (gallons).
B.
Press the R button to cycle between - - (off) and
(liters). When metric units are active, the indicator bar below the digits is displayed during Normal
Operation.
C.
When the desired setting is displayed, press the P button.
Restore Factory Defaults
Step 3
A.
All of the side indicators will blink and the display reads - -.
B.
To restore factory defaults, press the R button to cycle the display to
current settings, leave the display showing - -.
Note: Restoring the factory defaults will erase any programming you have done, including changing
the controller units and setting the clock.
C.
When the desired setting is displayed, press the P button and return to Normal Operation.
WaterBoss Softener Two-Button Owner's Manual
(on). Choosing
5/12/2011
will set the units to metric
. If you want to retain your
17
Hide quick links:
Advertisement
Table of Contents
